17Additional information

Message

Explanation/Action

• Repairing disc.

During recording, the power was cut. This display

• Repairing the HDD.

appears when the power is restored.

 

 

• Could not repair the disc.

The recorder was unable to repair the disc after a

 

power cut. The contents of the recording will be lost.

Overheating has stopped operation. The internal temperature of the recorder has

Press DISPLAY to clear message.

exceeded the operating limit. If this message

 

reappears, please ask your nearest Pioneer-

 

authorized service center or your dealer to carry

 

out repairs.

HDD optimization is recommended. This can be done using Disc Setup.

The HDD should be optimized (basically, HDD housekeeping) to maintain playback and recording performance.

Please perform HDD optimization. The HDD is in more urgent need of optimization in

This can be done using Disc Setup.

order to maintain performance.

 

 

• The HDD has not been sufficiently

If this message appears repeatedly after

optimized. Please optimize again.

optimizing the HDD it is likely that there is not

 

enough free space on the HDD for optimization to

 

complete properly. Please erase some titles from

 

the HDD and optimize again.

An error occurred. Please consult the service center. Note that contents on the HDD may be erased when servicing this unit.

The Hard Disk Drive info is incorrect. Use the Disc Setup menu to reinitialize.

This message is displayed when information from the HDD cannot be read. The HDD may be damaged or broken. Please ask your nearest Pioneer-authorized service center or your dealer to carry out repairs.

As the HDD info cannot be properly read, no new recordings can be made. Reinitializing the HDD (page 123) may result in your being able to make recording again. Note that reinitializing the HDD will erase all recorded contents, including protected files.

This signal’s TV system is different The TV system (PAL, NTSC, etc.) of the current

from the recorder’s setting.

channel is different from the TV system settings of

 

this recorder.

Recording failed due to a TV system The timer recording failed because the TV system

mismatch. Press DISPLAY to clear

of the channel set for recording was different from

message.

the setting of the recorder.

Playback has stopped because the TV During recording or timer recording standby, the system is different than the recording. TV System (PAL, NTSC, etc.) of the playback video

changed, causing playback to stop automatically.

152

En

Page 152
Image 152
Pioneer DVR-LX60D manual Repairing disc, Press Display to clear message, This can be done using Disc Setup