Pioneer DVR-LX60D manual Set the picture quality/recording time, Start recording

Recording 07

	CHANNEL
	+
3	–	Select a TV channel to record.

CHANNEL

The front panel display shows the channel number, or channel name if it’s available:

A.TV Channel preset

•While the recorder is stopped, you can also use the number buttons on the remote to select the channel (For channel 24, press 2, 4 then ENTER).

•If the recorder is stopped, you can also use the CH +/– buttons on the front panel to select the channel number.

REC MODE

4 Set the picture quality/recording time.

•See Setting the picture quality/recording time on page 64 for detailed instructions.

AUDIO

5 If you’re recording from the A.TV tuner, select the audio channel to record. See Changing A.TV audio channels on page 63 for more on this.

•When recording in VR mode, if a broadcast is bilingual, both audio channels are recorded, allowing you to switch the audio channel on playback. The only exception to this is when the picture quality is set to LPCM, in which case you do need to select the audio channel before recording.

AUDIO

6 If you’re recording from the D.TV tuner, select the audio language to record.

•You may also be able to set which

subtitle language to record; use SUBTITLE to select.

•Note that audio and subtitle languages cannot be changed during the recording of a digital broadcast.

REC

7 Start recording.

If you want to set a recording end time, press the REC button repeatedly. The recording time increases in 30 minute increments, up to a maximum of six hours. The time the recording will end is shown on-screen and in the front panel display. When the recording ends, the recorder automatically switches into standby if no other operation is being performed.

•To cancel the set recording time, press REC.

•If you want to pause recording at any time1, press PAUSE. Press again to restart the recording (If recording to the HDD, DVD-RAM or in VR mode, a new chapter is started after recording restarts).

STOP REC

8 Press to stop recording.

•If you set the recording time in the previous step, you can still stop the recording anytime by pressing

STOP REC.

•Recording will stop automatically when there is no more space on the HDD/ DVD, or after 12 hours of HDD recording (whichever is sooner).

Tip

•During recording you can turn on/off the SCART loop through function. During recording, press the front panel CH + button to switch to SCART THRU (loop through on), or CH – to switch to SCART NORM (loop through off). Loop through is automatically reset to off after recording has finished. Note that you can’t switch loop through on if recording from the AV1(RGB)-TVconnector.

Note	65
1 Except during Chase Play.
	En