Additional information

17

 

 

 

Problem

Remedy

 

 

 

 

No picture

• Check that everything is connected properly (page 14).

 

Check that the connected TV and/or the AV amp/receiver is set to the correct input.

The recorder may be set to progressive scan with an incompatible

TV. Reset to interlace by pressing and holding the front panel (Stop) button then pressing OPEN/CLOSE.

If you are using an indoor antenna that requires power, make sure that Aerial Power in the Initial Setup menu is set to On or Auto (page 129).

If the aerial/antenna is not connected properly, or if it is shorted, the Aerial Power setting will revert to Off automatically. Check the aerial connection and try making the setting again.

When the HDMI signal is output, no video is output from the

COMPONENT VIDEO OUT.

No sound or sound is distorted

Make sure that the amp/receiver or TV is set to the correct input and the volume turned up.

There is no sound when the picture is paused, or during scanning or slow motion play. Press PLAY to resume regular playback.

DTS discs can only be played if this recorder is connected to a DTS decoder or DTS compatible amp/receiver. If you have connected a suitable decoder, also make sure that the Initial Setup > Audio Out > DTS Out setting is On.

Some 96 kHz discs do not output audio through the digital jack. In this case, switch the input of your amp/receiver to analog.

Check the audio cable connections (page 14).

If the sound is distorted, try cleaning the cable plugs.

Cannot switch a

• During real-time copying it is not possible to switch audio channels.

bilingual programme

The main and sub channels are both output.

 

 

The picture from the

• If the video signal from the external component is copy-protected,

external input is

you cannot connect via this recorder. Connect the component directly

distorted

to your TV.

The picture is distorted • Change the Input Line System setting (page 141). (You can also change it by pressing the (Stop) button and INPUT SELECT on the front panel simultaneously with the recorder stopped.)

Screen is stretched

• Make sure that the TV Screen Size setting (page 137) is correct for

vertically or

the kind of TV you have (see also page 155).

horizontally

• If you have a widescreen TV, check its aspect ratio settings.

 

• This recorder’s input switches into wide mode automatically

 

according to the input signal. When the unit connected is not

 

compatible with VIDEO ID-1 (widescreen signalling), set the

 

connected component to output 4:3 aspect ratio (standard) video.

Audio/subtitle language cannot be changed

Note that audio and subtitle languages cannot be changed during the recording of a digital broadcast.

You can only use the audio track and subtitles for the language that were selected at the time of recording a digital broadcast. The audio

track and subtitles cannot be changed to other languages.

147

 

En

Page 147
Image 147
Pioneer DVR-LX60D No sound or sound is distorted, Cannot switch a, Distorted To your TV, Screen is stretched, Horizontally