Pioneer DVR-LX60D manual Additional information about the TV system settings, About Ntsc on PAL TV

The Initial Setup menu 16

Additional information about the TV system settings

About the input line system

This recorder is compatible with PAL, SECAM, 3.58 NTSC and PAL-60 TV systems. The Input Line System and Input Colour System settings determine how the recorder treats incoming video signals from an external input.

Please note the following points when changing the input line system:

•When the current input is a built-in tuner channel preset, changing the input line system will usually also affect the input line system of the AV2 (INPUT 1/ DECODER) input. However if the AV2/L1 In setting is set to Decoder, then the L2 input is affected instead.

•If, when the Input Line System setting is changed, the screen goes blank (due to incompatibility with your TV), you can switch back by pressing and holding the

front panel (Stop) button then pressing INPUT SELECT (also front panel) while the recorder is stopped.

•When you switch the Input Line System setting the Copy List is erased. If you

switch the setting using the (Stop) button and INPUT SELECT buttons as described above, there is no confirmation, so please use with care.

•You can’t mix recordings of different TV line systems on the same disc.

•When you change this setting, the Input Colour System setting also changes (see below).

About NTSC on PAL TV

Depending on the Input Line System setting and the NTSC on PAL TV setting, the signal format output when the recorder is stopped varies as shown in the table below.

Input Line	NTSC on PAL	Output
		when
System	TV	stopped
625 System	Off	PAL
	On	PAL
525 System	Off	NTSC
	On	PAL–60

About the input colour system

The available options of the Input Colour System setting depend on the Input Line System setting. The table below shows the different options available.

Input Line	Built-in	External
System	analog tuner	input
625 System	Auto	Auto
	PAL	PAL
	SECAM	SECAM
525 System	n/a	Auto
		3.58 NTSC
		PAL–60

Additional information about component video output

If you switch the Component Video Out setting to Progressive when using a TV that is not compatible with progressive-scan video, you will not be able to see anything displayed on your TV. If this happens, press and hold the (Stop) button on the front panel, then press OPEN/CLOSE. This will set the recorder’s video output back to Interlace.

141

En