Additional information | 17 |
Message | Explanation/Action |
•You are not allowed to watch this Conditional Access Programme.
A CA module or smart card (obtained from your service provider) is required to watch the selected programme. Insert the supplied module or card into the Common Interface card slot on the front panel of the recorder (page 25).
•There is no DV input or the input signal is unrecordable.
No signal was detected at the DV IN jack. This may appear if a blank section of DV tape is playing in the connected camcorder.
• No DV camcorder connected.
The camcorder is not connected properly, or the camcorder is switched off.
•You cannot connect more than one This recorder’s DV jack supports connection to
DV camcorder at a time. | just one camcorder. |
•Cannot operate the DV camcorder. This recorder cannot operate the DV camcorder. Try switching off the camcorder then turn it back on again.
•Could not operate the DV camcorder. This recorder was not able to operate the DV camcorder.
•The DV camcorder is not set for playback. Please select playback mode on the DV camcorder.
The camcorder is in camera mode. Switch it to playback mode.
•The printer is not ready or is not connected. Please check the printer.
This message is displayed when communication could not be established with the printer. See the Troubleshooting section if you do not know the cause.
• Printing has been cancelled | This message is displayed when there is a printer |
because ... | error during printing. After checking the printer for |
| the cause of the error, either reconnect the printer |
| and start the printing job again, or select “Yes” to |
| resume printing (select “No” to cancel the print |
| job). See also the operating instructions that came |
| with your printer for possible causes of print |
| errors. |
|
|
153
En
