09Playing and recording from a DV camcorder
1Make sure your DV camcorder is connected to the front panel DV IN jack. Also, set the camcorder to VTR mode.
REC MODE
2
Set the recording quality.
•See Setting the picture quality/recording time on page 64 for detailed information.
3From the Initial Setup menu, check that the DV audio input is setup as you would like.
See DV Input on page 133 for more on this.
•Check also that the Audio In settings for External Audio and Bilingual Recording are as you want them (see Audio In on page 132).
4HOME MENU Select ‘DV’, then ‘Copy from a DV Source’ from the Home Menu.
•DV recording only works when the DV camcorder is in VTR mode with a tape loaded.
ENTER
5Select ‘Record to Hard Disk Drive’ or ‘Record to DVD’.
6Find the place on the camcorder tape that you want to start recording from. For best results, pause playback at the point from which you want to record.
•Depending on your camcorder, you can use this recorder’s remote to control the
camcorder using the , | , | , | , | ||
, | and | buttons. |
|
|
|
ENTER |
|
|
|
|
|
7 | Select ‘Start Rec’. |
|
| ||
| Stop |
|
| Stop |
|
| 1.02.22 |
|
|
|
|
Control with these |
| Start Rec |
| ||
buttons |
|
| Pause Rec |
| |
|
|
|
| ||
|
|
| Stop Rec |
|
|
|
| HDD | SP | (2h00m/DVD) |
|
|
| Rem. |
| 32h45m |
|
• You can pause or stop the recording by selecting Pause Rec or Stop Rec from the
86control during recording.
•If you restart recording after stopping the camcorder, the first few seconds of the camcorder tape will not be recorded.
Use the pause button on your camcorder instead and recording will start immediately.
•HDD, DVD (VR Mode) and
•If you don’t want to see the DV recording screen during recording, press DISPLAY to hide it (press again to display).
•While recording, you cannot exit the DV recording screen using the HOME MENU or RETURN/EXIT button.
DV Auto Copy
DV Auto Copy allows you to make an exact copy of the contents of a DV source to the HDD or a DVD.
1Make sure your DV camcorder is connected to the front panel DV IN jack. Also, set the camcorder to VTR mode.
REC MODE
2
Set the recording quality.
•See Setting the picture quality/recording time on page 64 for detailed information.
3From the Initial Setup menu, check that the DV audio input is setup as you require.
See DV Input on page 133 for more on this.
•Check also that the Audio In settings for External Audio and Bilingual Recording are as you want them (see Audio In on page 132).
4HOME MENU Select ‘DV’, then ‘DV Auto Copy’ from the Home Menu.
•DV recording only works when the DV camcorder is in VTR mode with a tape loaded.
En
