To use washer again:
1.Flush water pipes,
2.Reconnect water inlet hoses to faucets.
3.Turn on both water faucets.
E_ectrica_ Shock Hazard
P_ug into a grounded 3 prong outlet.
Do not remove ground prong,
Do not use an adapter,
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrica_ shock,
4.Plug in washer or reconnect power.
5.Run the washer through the Normal/Casual cycle. Use only
HE High Efficiency detergent. Use 1/4the manufacturer's recommended amount for a medium sized load.
To transport the washer:
1.If washer will be moved during freezing weather, put in 1 qt (1 L) of
2.Unplug the power cord.
3.Disconnect the drain hose from the drain system and attach to rear panel clips,
4.Shut off both water faucets,
5.Disconnect the water inlet hoses from faucets, then drain the hoses and clip them to the rear panel of the washer.
6.IMPORTANT: Call service. Do not reuse transport bolts. Unit must be transported in the upright position. To avoid suspension and structural damage, your machine must be properly set up for relocation by a certified technician.
Reinstalling the washer
1.Follow the "Installation Instructions" to locate, level and connect the washer.
2.Run the washer through the Normal/Casual cycle to clean the washer and remove the antifreeze, if used. Use only HE High Efficiency detergent. Use 1/4the manufacturer's recommended amount for a medium sized load.
TROUBLESHOOTING
First try the solutions suggested here to possibly avoid the cost of a service call...
Error codes
When all cycle indicator lights are blinking, see which status light is also illuminated and then check the list below for potential problem and troubleshooting checks, An error code may be shown in the Estimated Time Remaining display (on some models),
•"Rinse" and "Clothes Clean" Status Light illuminated or "F20" on display (on some models) (Water Inlet
Select PAUSE/CANCEL twice to cancel the cycle. Unplug washer or disconnect power.
Check the following:
Are water faucets completely turned on?
Are screens at inlet hose connection to washer clogged? Are water inlet hoses kinked?
Are water inlet hoses frozen?
Electrical Shock Hazard
Plug into a grounded 3 prong out_et,
Do not remove ground prong,
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or eiectrica_ shock.
Plug in washer or reconnect power,
21
