Emerson 1HDEZ-1521 installation instructions Items on the Advanced Installer Menu are

Page 13

Advanced Installer Menu

From the Home screen press the and buttons at the same time for three seconds.

Press Enter button to save any changes and display the previous menu or press Home to display the Home Screen.

Items on the Advanced Installer Menu are:

Communicating Devices – select system configuration options

Fault Status – indicates equipment faults that have been detected

USB Upload – select thermostat settings to be uploaded from a pre-loaded USB

Thermostat Summary – indicates software version of thermostat

Heat Pump Lockout* – disable heat pump below a selectable temperature (when using electric Aux heat)

Dual Fuel Setpoint* – disable heat pump below a selectable temperature

(when using fossil fuel Aux heat – dual fuel)

Aux Lockout* – disable Aux heat above a selectable temperature

Heat Cycle Rate – adjust the duration for a call for heating

Cool Cycle Rate – adjust the duration for a call for cooling

Humidity Display Adjust – off-set the humidity that is displayed

Installation Test – equipment test for communicating systems only

*May or may not appear in the list depending on the configuration of the system

Important: Allow up to 5 minutes for menu options to become available after changing settings.

ADVANCED INSTALLER MENU

13

Image 13
Contents Emerson Inspire Index Configuration Applications Maximum Options Stages Applications and SpecificationsInstallation Equipment Control HM2 Equipment Control Terminals Operation / FunctionWiring to Typical Connection of a Single Stage or Multi-Stage System Wiring Guide for Equipment Accessories Fan Thermostat Thermostat and Equipment Control Wiring Power SystemItems on the Advanced Installer Menu are Advanced Installer MenuCommunicating Devices Communicating DevicesEquipment Control Outdoor IndoorRev Valve HUM Found. Installation Failed Faults StatusUSB Upload Heat Pump Lockout outdoor sensor required Thermostat SummaryDual Fuel Setpoint outdoor sensor required Humidity Display Adjust Aux Lockout Temperature outdoor sensor requiredHeat Cycle Rate Cool Cycle RateCheck System Operation Installation TestDisplay Settings Clock and Display SettingsMain Menu Navigating through your thermostat menusTime and Day Display Heating ProgramOutdoor Temp Display Humidity DisplayCooling Program Thermostat SettingsFactory Pre-Programmed Heating and Cooling Schedule Main Menu Main Menu Main Menu Main Menu Reset Operation TroubleshootingTemperature Display Adjust Symptom Possible Cause Correction Action No CoolTemperature Heat, Cool or FanNumber Displayed 7 Segment LED Equipment Control Fault CodesSystem Communication Codes Page Part no -7343B
Related manuals
Manual 20 pages 19.18 Kb