Emerson 1HDEZ-1521 installation instructions Main Menu

Page 26

MAIN MENU

Main Menu

Comfort or Dehum – Default is Off. Selecting either Comfort or Dehum will automatically reduce indoor humidity with a call for cooling if humidity is 2% above the humidity setpoint. If Comfort is selected, the system will slow the fan speed (variable speed blowers only) to increase the dehumidification process and cool based on the temperature

setpoint. If Dehum is selected, the system makes the dehumidification a priority over temperature. This setting uses more energy and may over-cool the space by up to to achieve the desired humidity level. If Off is selected the system will control temperature to the cooling setpoint.

EMR (Energy Management Recovery) Default is On. With EMR selected On, the heating or cooling system will start early so the temperature in your home is at the desired temperature at the beginning of the program period. If set to Off, the system will not start until the beginning of the program period.

Maximum Heat Setpoint Temp. Default is 99°. Minimum Cool Setpoint Temp. – Default is 45°. These settings are the highest temperature limit in Heat mode or the lowest temperature limit in Cool mode. Select a setting of 99° to 45° for the maximum heating temperature or 45° to 99° for the minimum cooling temperature.

26

Image 26
Contents Emerson Inspire Index Applications and Specifications Configuration Applications Maximum Options StagesInstallation Equipment Control Equipment Control Terminals Operation / Function HM2Wiring to Typical Connection of a Single Stage or Multi-Stage System Wiring Guide for Equipment Accessories Fan Thermostat Power System Thermostat and Equipment Control WiringAdvanced Installer Menu Items on the Advanced Installer Menu areEquipment Control Communicating DevicesCommunicating Devices Rev Valve IndoorOutdoor HUM USB Upload Faults StatusFound. Installation Failed Dual Fuel Setpoint outdoor sensor required Thermostat SummaryHeat Pump Lockout outdoor sensor required Heat Cycle Rate Aux Lockout Temperature outdoor sensor requiredHumidity Display Adjust Cool Cycle RateInstallation Test Check System OperationMain Menu Clock and Display SettingsDisplay Settings Navigating through your thermostat menusOutdoor Temp Display Heating ProgramTime and Day Display Humidity DisplayFactory Pre-Programmed Heating and Cooling Schedule Thermostat SettingsCooling Program Main Menu Main Menu Main Menu Main Menu Troubleshooting Reset OperationTemperature Symptom Possible Cause Correction Action No CoolTemperature Display Adjust Heat, Cool or FanSystem Communication Codes Equipment Control Fault CodesNumber Displayed 7 Segment LED Page Part no -7343B
Related manuals
Manual 20 pages 19.18 Kb