Emerson 1HDEZ-1521 Symptom Possible Cause Correction Action No Cool, Heat, Cool or Fan, Displayed

Page 29

Troubleshooting

Symptom

Possible Cause

Correction Action

 

 

 

No Cool

1. Cooling system

 

 

requires service.

 

 

 

 

Heat, Cool or Fan

1. Possible short in

Check each wire connection

Runs Constantly

wiring.

to verify they are not shorted

 

2. Possible short in

or touching together. No

 

thermostat.

bare wire should stick out

 

3. Possible short in heat/

from under terminal block.

 

cool/fan system.

Try resetting the thermostat

 

4. FAN Switch set to Fan

as described above. If the

 

ON.

condition persists, the

 

 

manufacturer of your system

 

 

can instruct you on how to

 

 

test the Heat/Cool system

 

 

for correct operation. If the

 

 

system operates correctly,

 

 

replace the thermostat.

 

 

 

Displayed

1. Thermostat display

The display can be adjusted

Thermostat

setting

+/- 5 degrees. Adjust the

Reading and

requires adjustment.

Temperature Display Adjust

Thermometer

 

settings within Thermostat

Disagree

 

Settings (see Main Menu

 

 

options).

 

 

 

Furnace (Air

1. The location of the

Adjust the Heat Cycle Rate

Conditioner)

thermostat and/or

or Cool Cycle Rate in the

Cycles Too Fast

the size of the Heat-

Advanced Installer Menu.

or Too Slow

ing System may be

 

(narrow or wide

influencing the cycle

 

temperature

rate.

 

swing)

 

 

 

 

29

TROUBLESHOOTING

Image 29
Contents Emerson Inspire Index Configuration Applications Maximum Options Stages Applications and SpecificationsInstallation Equipment Control HM2 Equipment Control Terminals Operation / FunctionWiring to Typical Connection of a Single Stage or Multi-Stage System Wiring Guide for Equipment Accessories Fan Thermostat Thermostat and Equipment Control Wiring Power SystemItems on the Advanced Installer Menu are Advanced Installer MenuEquipment Control Communicating DevicesCommunicating Devices Rev Valve IndoorOutdoor HUM USB Upload Faults StatusFound. Installation Failed Dual Fuel Setpoint outdoor sensor required Thermostat SummaryHeat Pump Lockout outdoor sensor required Humidity Display Adjust Aux Lockout Temperature outdoor sensor requiredHeat Cycle Rate Cool Cycle RateCheck System Operation Installation TestDisplay Settings Clock and Display SettingsMain Menu Navigating through your thermostat menusTime and Day Display Heating ProgramOutdoor Temp Display Humidity DisplayFactory Pre-Programmed Heating and Cooling Schedule Thermostat SettingsCooling Program Main Menu Main Menu Main Menu Main Menu Reset Operation TroubleshootingTemperature Display Adjust Symptom Possible Cause Correction Action No CoolTemperature Heat, Cool or FanSystem Communication Codes Equipment Control Fault CodesNumber Displayed 7 Segment LED Page Part no -7343B
Related manuals
Manual 20 pages 19.18 Kb