Aprilaire 8336 user manual Mark placement of mounting holes. See . Set base aside, Mounting Holes

Page 4

5.Place thermostat against the wall at desired location. Make sure wires will feed through opening on base of thermostat.

6.Mark placement of mounting holes. See Fig. 3. Set base aside.

Mounting Holes

Batteries NOT Required.

figure 3

7.Drill the marked holes using a 3/16" drill bit. NOTE: Enclosed plastic anchors do not require a drilled hole for drywall.

8.Tap plastic anchors into the wall.

9.Align base with plastic anchors and feed wires through opening.

10.Secure base to wall with supplied screws.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents
Model Features Replacing Existing ThermostatInstalling the Model 8336 Thermostat Remove the cover using a coin or screwdriverMark placement of mounting holes. See . Set base aside Mounting HolesSwitch Changing Temperature Differential OperationAt the same time and hold for one second Or buttonPut the COOL-OFF-HEAT-EM switch into the Heat position To Test ThermostatFew seconds Should turn offTroubleshooting LED IndicatorsChanging Fahrenheit F to Celsius C If problems with thermostat cannot be solved, call Wiring Diagrams Aprilaire Model 8336 Heat Pump ThermostatCYC Series Heat Pump Systems Heat Pump Systems Weathertron Lennox LOW Voltage Terminal Board Lennox LOW Voltage Terminal Board Limited Warranty