To Test Thermostat
WARNING: DO NOT SHORT (JUMPER) ACROSS TERMINALS OF GAS VALVE OR SYSTEM CONTROL TO TEST OPERATION. THIS WILL DAMAGE THE THERMOSTAT AND VOID YOUR WARRANTY.
CAUTION: Do not switch system to cool if the temperature is below 50°F (10°C). This can damage the air conditioning system and cause personal injury.
1.Place the
2. Press the >button until the temperature setting is at least 3 degrees below the room temperature. The air conditioning system should turn on within
a few seconds.
NOTE: When in the COOL mode (or HEAT for single stage heat pumps), once the thermostat turns off, a built in
3.Put the
4.Put the COOL-OFF-HEAT-EM switch into the HEAT position.
5. Press the> button until the temperature setting is at least
3 degrees above room temperature. The heating system should turn on. The fan may not turn on immediately, depending upon the fan delay built into the furnace.
6.Put the
7.Put the FAN:
8.Put the FAN:
should turn off.
FAN: AUTO - ON
FAN: AUTO - ON
7