Heath Zenith 598-1113-05 manual Electronic Chime Wiring TR-0070-BX Base Shown

Page 3

8.Route wires through wire entrance hole in new chime base.

9.Mount chime base to wall using screws and anchors provided. (Drill 7/32" diameter pilot hole for wall anchors.)

10.Connect wire “F” to screw terminal marked “FRONT”. Connect wire “T” to screw terminal marked “TRANS”. Connect wire “R” to screw terminal marked “REAR”* (See Figure 2).

11.Install chime cover (see page 4).

12.Connect diode to front push button (see page 5).

*Note: Some installations may not include rear door push button.

Existing Chime Wires

 

VOLUME

A

FRONT

B

TUNE

FRONT

F

TRANS

T

REAR

R

 

Replacement

Chime Base Rear Door Push Button

Wall

(if Applicable)

Figure 2 - Electronic Chime Wiring

(TR-0070-BX Base Shown)

- -

598-1113-05

Image 3
Contents Hardwired Electronic Chime Electronic Chime Identification TR-0070-BX Base Shown Chime Replacement InstallationElectronic Chime Wiring TR-0070-BX Base Shown Turning Over Cover Pin for Hanging Type Install Chime CoverAttaching Diode to Front Door Push Button Diode Installation InstructionsChime does not sound TroubleshootingONE Year Limited Warranty Technical ServiceChime System Wiring Diagram Campanas Con componentes Electrónicos Instalación DEL Reemplazo DE LA Base nueva de la campana Para tapas tipo cierre a presión Aplique presión a la tapa Instale LA Tapa DE LA CampanaFigura 5 Conexión del diodo al pulsador de la puerta frontal Instrucciones DE Instalación DEL DiodoLa campana no suena Análisis DE AveríasGarantía Limitada a 1 AÑO Servicio TécnicoEsquema eléctrico del sistema de la campana Carillons Électroniques Câblés Installation DU Carillon DE Rechange Câblage du carillon électronique Avec socle TR-0070-BX Installation DU Couvercle DU Directives D’INSTALLATION DE LA Diode Le carillon n’émet pas de son DépannageGarantie Limitée DE 1 AN Service TechniqueDiagramme de câblage du carillon