Hearth and Home Technologies 43ST-ACC warranty Appliance Set Up, Begin installing the ARS System

Page 21

 

R

4300 Wood Stove Series (ACC)

 

 

 

 

 

 

7

Appliance Set Up

 

 

 

A.Pedestal Assembly and Ash Removal System (ARS) Installation for Step Top Uni-body

NOTE: The Ash Removal System, must be installed first before installing the pedestal.

Included in Kit: Door assembly, door handle & magnet, ash drawer, fastener package. A cover plate that is required for a floor outside air installation on a pedestal model is also included, If not needed, discard.

Tools Required: Phillips head screwdriver, 7/16 socket wrench, 3/32 and 5/36 Allen wrench.

Begin installing the ARS System.

1.Remove 2 front bricks as shown in Figure 21.1.

2.Lay body of stove on its back on a protective pad or pallet.

3.Remove the 2 nuts and 2 bolts holding the channel in place and set the channel aside. Discard the 2 nuts. Install the gasket over the 4 protruding screws.

The glossy side of the gasket needs to go against the firebox bottom.

It is important the gasket is not put on upside down as it could compromise its sealing capa- bilities. Figure 21.2.

4.Install ash door assembly by sliding the rod at an angle into the slot on the left side. As the rod starts passing through the slot, slide the handle over the rod and then finish pushing the rod through the slot.

Slide the ash door over the 4 screws protruding from the bottom of the stove. Secure with nuts provided. Figure 21.2.

5.Using a 3/32 Allen wrench tighten the set screw in the door handle. The set screw needs to be snug. Figure 21.3.

6.Install magnet using a Phillips head screwdriver. This magnet will hold the door handle in an open position which in turn holds the ash door open so ashes can be brushed into the ash drawer. Figure 21.2.

WARNING

Do NOT operate before fully assembling components.

Burning your stove without a pedestal or leg kit attached:

Will void your warranty.

May result in property damage or personal injury.

Remove for

installation and

then re-install

Figure 21.1

Door Handle

Gasket

Lay stove flat on

protective padding or

pallet

Magnet

Slide rod at an

angle into slot

Ash Door

Assembly

Figure 21.2

Set Screw

(align with flat

side of rod)

Ash Door Rod shown in installed position

Door handle must be in open position to tighten set screw

Figure 21.3

September 1, 2008

7037-135E

Page 21

Image 21
Contents Hot glass will cause burns Step Top Uni-Body Model Millennium Model7037-135E September 1 Pedestal Model ShownMfg. Date 7037-135E September 1 Wood Stove Series ACCTable of Contents Glass Specifications Appliance Certification BTU & Efficiency SpecificationsListing and Code Approvals Mobile Home ApprovedGetting Started Fire SafetyWood Stove Series ACC Negative Pressure Appliance needs to draft properly for safetyVenting Systems Wood Stove Series ACC Flue Draft ConsiderationsTools And Supplies Needed Inspect Appliance & Components and Pre-Use Check ListMasonry Chimney Wood Stove Series ACC Typical Stove SystemsDimensions and Clearances Appliance DimensionsMillennium Model 170mm 11/1611/16 in mm 89mm Back of Stove to Glass 25-/8 645mm 10-/8 264mmWood Stove Series ACC Clearances to Combustibles UL and ULC Installation 90 Elbow Off Top of Stove Through BackwallWood Stove Series ACC 4300 InstallationHearth Protection Requirements Millennium ModelWood Stove Series ACC Step-Top Uni-Body Model Wood Stove Series ACC Outside Air Kit Installation Items Needed for Installation not suppliedFire Risk Asphyxiation Risk Shock Risk Wood Stove Series ACC Blower OptionalChimney Requirements Chimney ConnectorVenting Components Chimney Systems ThimbleAir Clearances ComponentsInstructions Solid Pack Chimney with Metal Supports as a ThimbleInstalling Chimney Components Solid Pack Chimney with Metal Supports as a Thimble Cont’dChimney Height / Rise and Run Rule Wood Stove Series ACC Chimney Termination RequirementsPitched Roof Flat RoofMobile Home Installation Begin installing the ARS System Appliance Set UpFinishing the ARS Installation Installing Pedestal AssemblySlip wooden decorative strips onto pedestal edges Front cut bricks. FigureCorners. Figure Installing Leg KitAdjusting The Blower Speed Control Wood Stove Series ACC Door Handle AssemblyOver-Firing Your Appliance Wood Selection & Storage Cont’d Operating InstructionsBurning Process Wood Selection & StorageAir Controls Automatic Combustion Control ACCBurn Rates and Operating Efficiency Wood Stove Series ACC Building a Fire Correct Position Initial cold start-up and all Burn Settings Frequently Asked Questions Opacity SmokeWood Stove Series ACC Blower Operating Instructions Snap Disc LocationAsh Removal System ARS Operating and Cleaning General MaintenanceCreosote Chimney Cleaning Maintaining & Servicing Your ApplianceCleaning Plated Surfaces Glass Cleaning Frequency As desiredWhen cleaning glass Disposal of AshesWood Stove Series ACC Glass Replacement Available for the Step Top Model and not Wood Stove Series ACC Firebrick ReplacementFor the Millennium Model To your authorized dealerSnap Disc Location Wood Stove Series ACC Baffle Removal Snap Disc ReplacementWood Stove Series ACC Tube Channel Assembly Replacement Removing Tube Channel AssemblyReplacing Tube Channel Assembly Start Fire Problems Possible Cause Solution TroubleshootingReference Materials Exploded viewDescription #29 Ceramic Blanket 19 w x 13-3/4 h, 1/2 thick #33 Baffle Board 2 w x 15-3/4 h, eachDoor, Cast not sold separately Step-Top Uni-Body ModelBlower Assembly Wood Stove Series ACC Service Parts & AccessoriesItem # Service Parts Item # Service Parts Date of Service Performed By Description of Service Wood Stove Series ACC Service And Maintenance LogWood Stove Series ACC Homeowner’s Notes CONDITIONS, Exclusions & Limitation of Liability September 1 7037-135E Contact Information

43M-ACC-MBK, 43ST-ACC specifications

Hearth and Home Technologies has long been a leader in the design and manufacturing of high-quality heating appliances, and their models 43ST-ACC and 43M-ACC-MBK are no exception. These gas fireplaces combine aesthetic appeal with innovative technologies aimed at providing efficient heating solutions for residential spaces.

The 43ST-ACC is designed with versatility in mind. It features a traditional style that can seamlessly integrate into a variety of home decors. One of its standout characteristics is the expansive viewing area that allows homeowners to enjoy the mesmerizing flames. The fireplace utilizes advanced ceramic glass technology that enhances the thermal efficiency, ensuring a warm environment without compromising on safety.

On the technical side, the 43ST-ACC is equipped with the IntelliFire ignition system which provides convenient, reliable startup. This system also allows for enhanced safety features, ensuring the unit operates smoothly and safely. The adjustable flame height and heat output settings further allow users to create their desired ambiance while optimizing fuel consumption.

Additionally, the 43M-ACC-MBK model is geared towards those who appreciate a modern, sophisticated design. This model is characterized by its sleek, black finish and clean lines, making it an eye-catching centerpiece in any room. Like the 43ST-ACC, it also boasts an impressive viewing area, but it comes with the added benefit of customizable features, including remote control operation and programmable thermostats.

Both models are designed with efficiency in mind, incorporating technology that maximizes heat distribution throughout the room. Their direct vent operation ensures that combustion gases are exhausted outside, making them a safe choice for indoor spaces. The inclusion of a blower system in both models enhances air circulation, providing an even distribution of warmth throughout the environment.

In conclusion, the Hearth and Home Technologies 43ST-ACC and 43M-ACC-MBK gas fireplaces combine style, functionality, and advanced technology. Whether you are looking for a traditional touch or a modern flair, these models cater to diverse preferences while ensuring efficient heating and safety. With their innovative features and beautiful designs, they truly represent the pinnacle of home heating solutions. Whether settling in for a cozy evening or entertaining guests, these fireplaces are sure to enhance any living space.