Hearth and Home Technologies 43ST-ACC, 43M-ACC-MBK warranty Getting Started, Fire Safety

Page 5

 

R

4300 Wood Stove Series (ACC)

 

 

 

 

 

 

2

Getting Started

 

 

 

A. Design, Installation & Location Considerations

Consideration must be given to:

•Safety

•Convenience

•Traffic flow

•Chimney and chimney connector required

It is a good idea to plan your installation on paper, using exact measurements for clearances and floor protection, before actually beginning the installation. If you are not using an existing chimney, place the appliance where there will be a clear passage for a factory-built listed chimney through the ceiling and roof.

We recommend that a qualified building inspector and your insurance company representative review your plans before and after installation

If this appliance is in an area where children may be near it is recommended that you purchase a decorative barrier to go in front of the appliance. Remember to always keep children away while it is operating and do not let anyone operate this appliance unless they are familiar with these operating instructions.

NOTE: Service Space:

In order to replace the tube channel a clearance of 19 inches (483mm) is required on the right side of stove in order to remove the tubes with the stove in place.

If space is not available, the stove will have to be discon- nected from the chimney to proceed with the tube replace- ment. See page 36.

CAUTION

Check building codes prior to installation.

•Installation MUST comply with local, regional, state and national codes and regulations.

•Consult insurance carrier, local building, fire officials or authorities having jurisdiction about restrictions, installation inspection, and permits.

B. Fire Safety

To provide reasonable fire safety, the following should be given serious consideration:

1.Install at least one smoke detector on each floor of your home to ensure your safety. They should be located away from the heating appliance and close to the sleeping areas. Follow the smoke detector manufacturer’s placement and installation instructions, and be sure to maintain regularly.

2.A conveniently located Class A fire extinguisher to contend with small fires resulting from burning embers.

3.A practiced evacuation plan, consisting of at least two escape routes.

4.A plan to deal with a chimney fire as follows: In the event of a chimney fire:

a.Evacuate the house immediately

b.Notify fire department

WARNING

Fire Risk.

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

•Installation and use of any damaged appliance.

•Modification of the appliance.

•Installation other than as instructed by Hearth & Home Technologies.

•Installation and/or use of any component part not approved by Hearth & Home Technologies.

•Operating appliance without fully assembling all components.

•Operating appliance without legs attached (if supplied with unit).

•Do NOT Overfire - If appliance or chimney connector glows, you are overfiring.

Any such action that may cause a fire hazard.

WARNING

Asphyxiation Risk.

•Do NOT connect this unit to a chimney flue servicing another appliance.

•Do NOT connect to any air distribution duct or system.

May allow flue gases to enter the house.

WARNING

Fire Risk.

•Do not operate appliance before reading and understanding operating instructions.

•Failure to operate appliance properly may cause a house fire.

September 1, 2008

7037-135E

Page

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Hot glass will cause burns Step Top Uni-Body Model Millennium Model7037-135E September 1 Pedestal Model ShownMfg. Date 7037-135E September 1 Wood Stove Series ACCTable of Contents Glass Specifications Appliance Certification BTU & Efficiency SpecificationsListing and Code Approvals Mobile Home ApprovedGetting Started Fire SafetyWood Stove Series ACC Negative Pressure Appliance needs to draft properly for safetyVenting Systems Wood Stove Series ACC Flue Draft ConsiderationsTools And Supplies Needed Inspect Appliance & Components and Pre-Use Check ListMasonry Chimney Wood Stove Series ACC Typical Stove SystemsMillennium Model Dimensions and ClearancesAppliance Dimensions 170mm 11/1611/16 in mm 89mm Back of Stove to Glass 25-/8 645mm 10-/8 264mmWood Stove Series ACC Clearances to Combustibles UL and ULC Installation 90 Elbow Off Top of Stove Through BackwallWood Stove Series ACC 4300 InstallationHearth Protection Requirements Millennium ModelWood Stove Series ACC Step-Top Uni-Body Model Fire Risk Asphyxiation Risk Wood Stove Series ACC Outside Air Kit InstallationItems Needed for Installation not supplied Shock Risk Wood Stove Series ACC Blower OptionalChimney Requirements Chimney ConnectorVenting Components Chimney Systems ThimbleAir Clearances ComponentsInstructions Solid Pack Chimney with Metal Supports as a ThimbleChimney Height / Rise and Run Installing Chimney ComponentsSolid Pack Chimney with Metal Supports as a Thimble Cont’d Rule Wood Stove Series ACC Chimney Termination RequirementsPitched Roof Flat RoofMobile Home Installation Begin installing the ARS System Appliance Set UpFinishing the ARS Installation Installing Pedestal AssemblySlip wooden decorative strips onto pedestal edges Front cut bricks. FigureCorners. Figure Installing Leg KitAdjusting The Blower Speed Control Wood Stove Series ACC Door Handle AssemblyOver-Firing Your Appliance Wood Selection & Storage Cont’d Operating InstructionsBurning Process Wood Selection & StorageAir Controls Automatic Combustion Control ACCBurn Rates and Operating Efficiency Wood Stove Series ACC Building a Fire Correct Position Initial cold start-up and all Burn Settings Frequently Asked Questions Opacity SmokeWood Stove Series ACC Blower Operating Instructions Snap Disc LocationAsh Removal System ARS Operating and Cleaning General MaintenanceCreosote Chimney Cleaning Maintaining & Servicing Your ApplianceCleaning Plated Surfaces Glass Cleaning Frequency As desiredWhen cleaning glass Disposal of AshesWood Stove Series ACC Glass Replacement Available for the Step Top Model and not Wood Stove Series ACC Firebrick ReplacementFor the Millennium Model To your authorized dealerSnap Disc Location Wood Stove Series ACC Baffle Removal Snap Disc ReplacementReplacing Tube Channel Assembly Wood Stove Series ACC Tube Channel Assembly ReplacementRemoving Tube Channel Assembly Start Fire Problems Possible Cause Solution TroubleshootingDescription Reference MaterialsExploded view #29 Ceramic Blanket 19 w x 13-3/4 h, 1/2 thick #33 Baffle Board 2 w x 15-3/4 h, eachDoor, Cast not sold separately Step-Top Uni-Body ModelBlower Assembly Wood Stove Series ACC Service Parts & AccessoriesItem # Service Parts Item # Service Parts Date of Service Performed By Description of Service Wood Stove Series ACC Service And Maintenance LogWood Stove Series ACC Homeowner’s Notes CONDITIONS, Exclusions & Limitation of Liability September 1 7037-135E Contact Information

43M-ACC-MBK, 43ST-ACC specifications

Hearth and Home Technologies has long been a leader in the design and manufacturing of high-quality heating appliances, and their models 43ST-ACC and 43M-ACC-MBK are no exception. These gas fireplaces combine aesthetic appeal with innovative technologies aimed at providing efficient heating solutions for residential spaces.

The 43ST-ACC is designed with versatility in mind. It features a traditional style that can seamlessly integrate into a variety of home decors. One of its standout characteristics is the expansive viewing area that allows homeowners to enjoy the mesmerizing flames. The fireplace utilizes advanced ceramic glass technology that enhances the thermal efficiency, ensuring a warm environment without compromising on safety.

On the technical side, the 43ST-ACC is equipped with the IntelliFire ignition system which provides convenient, reliable startup. This system also allows for enhanced safety features, ensuring the unit operates smoothly and safely. The adjustable flame height and heat output settings further allow users to create their desired ambiance while optimizing fuel consumption.

Additionally, the 43M-ACC-MBK model is geared towards those who appreciate a modern, sophisticated design. This model is characterized by its sleek, black finish and clean lines, making it an eye-catching centerpiece in any room. Like the 43ST-ACC, it also boasts an impressive viewing area, but it comes with the added benefit of customizable features, including remote control operation and programmable thermostats.

Both models are designed with efficiency in mind, incorporating technology that maximizes heat distribution throughout the room. Their direct vent operation ensures that combustion gases are exhausted outside, making them a safe choice for indoor spaces. The inclusion of a blower system in both models enhances air circulation, providing an even distribution of warmth throughout the environment.

In conclusion, the Hearth and Home Technologies 43ST-ACC and 43M-ACC-MBK gas fireplaces combine style, functionality, and advanced technology. Whether you are looking for a traditional touch or a modern flair, these models cater to diverse preferences while ensuring efficient heating and safety. With their innovative features and beautiful designs, they truly represent the pinnacle of home heating solutions. Whether settling in for a cozy evening or entertaining guests, these fireplaces are sure to enhance any living space.
Top Page Image Contents