Using Your Steam Mop

When you use your steam mop for the first time or if you have not used the unit in awhile, it may take a minute or two for the water to travel through the pump and into the heater to create steam.

If you have waited a few minutes and you still do not see any steam, reference the troubleshooting section on page 11.

fig. 1

fig. 3

fig. 2

IMPORTANT: Your steam mop needs water to make steam! Never use your steam mop without water in the tank.

Sweep or vacuum your floors prior to cleaning with your Steam Mop.

Visit www.sharkclean.com for other great quick cleaning products to complement your Steam Mop, such as the Shark® Navigator (model NV350).

1Pull and twist the quick release cord holder to unwrap the power cord completely. (fig. 1) Plug into a 120-volt electrical outlet. (fig. 2) The LED light will blink blue to show that you are in standby mode. If the light does not turn on, reference the troubleshooting section on page 9. (fig. 3)

2Press the STEAM button to activate the steam. The LED light will turn solid blue. When the STEAM button is pressed, the electronic pump will automatically generate steam and moisten the micro-fiber pad. (fig. 4)

TOLL FREE: 1-800-798-7398