Assembly Step 4
Install the Chain/Cable &
Attach the Sprocket Cover
Dispensing Carton
Leave Chain and Cable
Inside Dispensing
Carton to Prevent Kinking.
Keep Chain and CabIe
Taut When Dispensing
•Detach the cable loop from the carton and fasten it to the trolley with a master link from the hardware bag. See master link procedure, Figure 1.
•With the trolley against the screwdriver, dispense the cable around the pulley.
•Proceed back around the opener sprocket,
Figure 2. Be sure sprocket teeth engage the chain. Continue forward to the trolley threaded shaft, Figure 3.
• Use the second master link to connect the | Master | Link | ||
Spring | ||||
chain to the flat end of the shaft. Check | ||||
|
| |||
to make | sure the chain is not | Mast |
| |
twisted. |
| Link Cap | ||
• Remove | the screwdriver. |
|
|
Cable
Loop _.
Sable
Pulley
Install Chain and Cabte
In This Direction
Sprocket
Cover
Back Tab Slot
Top of Opener
Serious injury can result if fingers become entangled in moving opener sprocket. Attach sprocket cover securely. Never operate opener while your hand is near the opener sprocket.
| Opener |
Figure 2 | Sprocket |
|
Figure 3
Master Link
i
|
| Master |
|
| Link Cap |
|
| Flat End |
i | i | of TrolIey |
i | i | Threaded Shaft |
; | _ | Chain |
|
| |
|
| Pin Notch |
Master
LinkBar Figure 1
Master Link Procedure:
Push pins of master link bar through cable loop and hole in front end of trolley. Push cap over pins and into notches.
Slide
pins are securely locked.
Front Tab Slot
Mounting
Plate
To attach the sprocket cover:
•Insert the back tab in the opener slot. Squeeze the cover slightly and insert the front tab in the slot on the mounting plate.
10