Please read and comply with the warnings and reinforcement instructions on page 24. They apply to
Header Wall
- Finished Ceiling -
2x4 Support
Header |
| HodzontaI | and vertical | |
Bracket |
| |||
|
|
|
| |
Door | OptionaI | reinforcement | is needed for | |
Bracket | PIacement | lightweight | garage | doors |
| of Door | (fibergIass, aluminum, | steel, | |
| Bracket | door with glass paneI, etc.) |
VerticaI
Garage Door
For a |
|
|
|
|
|
|
|
exposed framing or | for | _ | ± | .............. | / | ||
theo_on, |
|
| _ _C_aS, | riage_B°]t,, | / | ||
use_ |
|
|
| v | ,_ |
| |
screw | (not | supplied) | to |
| "_ | / |
|
fasten | door | bracket |
| _ |
|
|
|
•Center the bracket on the top of the door, in line with the header bracket as shown. Mark holes.
•Drill 5/16" pilot holes and fasten the door bracket with hardware supplied.
If the door has no exposed framing, drill 3/16" pilot holes and fasten the bracket with
The door bracket may be installed on the top edge of the door if required for your installation. (Refer to the dotted line optional placement drawing.) Drill 3/16" pilot holes and substitute
Hardware Shown Actual Size
© ©
Nut 5/16%18 | Lock Washer 5/16" |
Carriage Bolt
25