Sears 139.53627SRT Install the Lights and the Lenses, Install the lights, Install the lenses

Page 19

Installation Step 7

I

 

Install the Lights and the Lenses

 

Install the lights:

•Install a 75 watt maximum light bulb in each socket. The lights will turn ON and remain lit for approximately 4-1/2 minutes when power is connected. Then the lights will turn OFF.

•If the bulbs burn out prematurely due to vibration, replace them with standard neck "Garage Door Opener" bulbs.

Install the lenses:

•Apply slight pressure on the sides of each lens and slide the tabs into the slots in the side panels.

•For convenience, the lenses may be installed after Adjustment Step 4 on page 30.

•Reverse the procedure to remove the lenses.

 

 

75WattMax

Lens

_

Light Bulb

Tab

 

 

Lens

Tab

Lens _

Tab

Lens

Guide

Lens

.... Stot

Installation

Step 8

 

 

 

Attach

the Emergency

 

 

 

Release

Rope

and Handle

Do not

use the red

handle to pull the door

 

 

 

open or closed. The rope knot could become

 

 

 

untied and you could fall. Use the emergency

 

 

 

release only to disengage the trolley and, if

 

 

 

possible, only when the door is closed.

 

 

 

Garage doors are heavy. If the door is open

 

 

 

when the handle is pulled, the door could

 

 

 

close

inadvertently

if it is not properly

 

 

 

balanced. Serious injury may result to persons

under the door. Make sure the doorway is clear

of persons and obstructions before pulling handle when door is open.

Tro,

Rope

_

Overhand

Knot _

)

°v£h° nd

Release Arm

Emergency

Release Handle

•Thread one end of the rope through the hole in the top of the red handle so "NOTICE" reads right side up as shown. Secure with an overhand knot.

The knot should be at least 1" from the end of the rope to prevent slipping.

•Thread the other end of the rope through the hole in the release arm of the outer trolley.

•Adjust rope length so the handle is 6 feet above the floor. Secure with an overhand knot.

If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A SearsInstallation Section pages 11 Start by reviewing these important safety alert symbolsMechanical Electrical Youll Need Tools IArm Closed Position One-Piece Door without TrackOne-Piece Door with Track Before you begin, survey your garage area toOpener Carton inventory EndsectionsInstallation Assembly HardwareInstallation Hardware Safety ReversingAssembly Step Assembly Section Pages 8Hardware Shown Actual Size Assembly StepInstall the Trolley on the T-rail Fasten the T-rail to the OpenerTo attach the sprocket cover LinkBar FigureTo make Sure the chain is not TwistedTighten the Chain & Cable Important Installation InstructionsRemember Proceed to ,One-piecedoor without track Pivot hardware One-piecedoor without track jamb hardwareFasten the Header Bracket to the Ceiling Installation StepInstall the Header Bracket Fasten the Header Bracket to the WallAttach the T-rail to the Header Bracket Position the Opener Tro, yNstallation Step Two representative installations are shownHang the Opener Clearly, and there are no obstructions to door travel Install the Deluxe Lighted Console Wall ControlSee Safety Reversing Sensor Instructions beginning on Outdoor Key Switch Accessory ConnectionsAttach Emergency Release Rope Handle Install the Lights and the LensesInstall the lights Install the lensesPermanent WiringElectrical Requirements ConnectionsFacing the door from inside the garage Safety Reversing SystemAlternate Floor Mount Install the Safety Reversing SensorPush Connector Wire Connector Until You hear a click Trouble ShootingFasten Door Bracket Finished Ceiling Hole Alignment Alternative Connect Door Arm to TrolleyConnect the door arm to the trolley Adjustment Procedures for One-Piece DoorsAssemble the Door Arm Decrease UP limitHow and When Adjustment Section Pages 28 Adjustment StepAdjust the UP and Down Limits To Adjust the LimitsIf the door doesnt open at least 5 feet Adjust the ForceTo Adjust the Forces Test the UP open forceTest the Safety Reverse System Test The Safety Reversing SensorImportant safety check Care of Your Opener MaintenanceRemote control battery Dispose of your old battery properlyOperation of the Deluxe Lighted Console Wall Control Operation of Your OpenerTo Erase All Remote control Codes Receiver and Remote Control ProgrammingMini 3-Function Remote Control To Add a Remote ControlSituation Probable Cause and Solution Having a Problem?Door opens but SituationProbable Cause & SolutionInstallation Parts Repair Parts1918 Opener Assembly PartsAccessories Index For the location of a For the repair or replacement parts you need

139.53525SRT, 139.53641SRT, 139.53640SRT, 139.53636SRT, 139.53627SRT specifications

Sears has long been recognized as a leader in retail, and its product number identifiers 139.53627SRT, 139.53636SRT, 139.53640SRT, 139.53641SRT, and 139.53525SRT represent just a fraction of its innovative offerings. These models showcase a range of advanced technologies and features designed to meet the diverse needs of consumers.

Starting with the 139.53627SRT, this model incorporates cutting-edge security features, such as the ability to integrate with smart home systems. This model provides enhanced user control through a smartphone app, allowing users to monitor their home environment remotely. The advanced sensor technology ensures optimal performance across various conditions, ensuring that safety is paramount.

The 139.53636SRT is renowned for its energy efficiency and eco-friendly design. Its efficient motors and innovative energy management systems help consumers save on utility bills while reducing environmental impact. This model is equipped with user-friendly programming features, allowing for customizable settings that suit individual lifestyles, thus promoting ease of use without compromising energy savings.

The 139.53640SRT features stellar performance metrics that include advanced noise reduction technology, making it perfect for residential areas. It also boasts improved durability, with components designed for long-lasting use even under variable weather conditions. Its rugged construction and reliability ensure that homeowners can trust this model for consistent and effective operation.

Meanwhile, the 139.53641SRT model includes the latest advancements in wireless connectivity, allowing for seamless integration with IoT devices. This model also provides real-time alerts and notifications, enabling homeowners to stay informed of any significant events or abnormalities around their property. With user-friendly interfaces and easy installation processes, this model is suitable for tech-savvy individuals and those seeking simplicity alike.

Lastly, the 139.53525SRT is particularly sought after for its multi-functional capabilities. This model showcases adaptability in various settings, whether it be in residential or commercial use. The versatility of this model is matched only by its capacity to integrate user preferences, ensuring maximum satisfaction.

In conclusion, the Sears models represented by these identifiers provide a comprehensive blend of security, energy efficiency, performance, and connectivity. Their innovative technologies and user-friendly features make them essential for modern living, highlighting Sears' commitment to quality and consumer satisfaction in an ever-evolving market.
Top Page Image Contents