Multiquip QP4TE manual Initial START-UP Engine, Normal Shutdown

Page 20

6.Grasp the starter grip (Figure 11) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingtothecompressionpoint.Pullthestartergripbriskly and smoothly for starting.

Figure 11. Starter Grip

7.If the engine has started, slowly return the choke lever (Figure 12) to the CLOSED position. If the engine has not started repeat steps 1 through 6.

INITIAL START-UP (ENGINE)

CAUTION

ALWAYS run engine at full speed while pumping.

Stopping The Engine

Normal Shutdown

1.Move the throttle lever to the IDLE position (Figure 14) and run the engine for three minutes at low speed.

Figure 12. Choke Lever (Closed)

8.Before the pump is placed into operation, run the engine for severalminutes. Checkfor fuelleaks,andnoisesthatwould associate with a lose component.

9.To begin pumping, place the throttle lever (Figure 13) in the "RUN"position.

Figure 13. Throttle Lever (Run)

Figure 14.Throttle Lever (Idle)

2.Aftertheenginecools,turntheengineON/OFFswitchtothe “OFF” position (Figure 15).

Figure 15. Engine ON/OFF Switch (OFF)

3.Place the fuel shut-off lever (Figure 16) in the OFF position.

Figure 16. Fuel Valve Lever (OFF)

Emergency Showdown

1.MovethethrottleleverquicklytotheIDLE position,andplace the engine ON/OFF switch in the OFF position.

PAGE 20 —OPERATION AND PARTS MANUAL — REV. #1 (10/10/08)

Image 20

Contents Model QP4TE Proposition 65 Warning Operation & Parts Manual REV. #0 01/25/06 Table of Contents Parts Ordering Procedures Ordering parts has never been easierSafety Information Safety MessagesGeneral Safety Engine Safety Fuel Safety Transporting Safety Operation and Parts Manual REV. #1 10/10/08 General Information ApplicationSpecifications Pump Specifications Engine Specifications EnginePump Components Used in general de-watering applications. TypicalBasic Engine Initial ServicingPRE-INSPECTION Engine InspectionPRE-SETUP Pump Before StartingInitial START-UP Engine Initial START-UP Engine Normal ShutdownMaintenance Pump Pump Vacuum TestPressure reading may vary Maintenance Engine Engine Maintenance Schedule24 -OPERATION and Parts Manual REV. #1 10/10/08 Preparation for Long -TERM Storage Pump StorageTroubleshooting Engine Troubleshooting ENGINE/PUMP Explanation of Code in Remarks Column Suggested Spare Parts QP4TE 1 to 5 Units withPump Assy Pump Assy 32 -OPERATION and Parts Manual REV. #1 10/10/08 Part Name QTY Remarks Robin EX270D50220 Engine AIR Cleaner Assy Base CP Robin EX270D50220 Engine Camshaft Assy PIN, CAMSHAFT, 9DX78.5L Robin EX270D50220 Engine Carburetor Assy Valve Throttle Robin EX270D50220 Engine Crankcase Assy Robin EX270D50220 Engine Crankcase Assy Robin EX270D50220 Engine CRANKSHAFT/PISTON Assy Crankshaft CP Robin EX270D50220 Engine Cylinder Head Assy Collet Valve Robin EX270D50220 Engine Fueltank Assy Part Name Robin EX270D50220 Engine Governor Assy Governor Lever Robin EX270D50220 Engine Ignition COIL/FLYWHEEL Assy Robin EX270D50220 Engine Ignition COIL/FLYWHEEL Assy Robin EX270D50220 Engine Muffler Assy Muffler CP Robin EX270D50220 Engine OIL Sensor Assy OIL Sensor CP Robin EX270D50220 Engine Recoil Starter Assy LABEL, Trade Mark 64D Terms and Conditions of Sale Parts Operation and Parts Manual REV. #1 10/10/08 HERE’S HOW to GET Help