Sears 385. 564180 owner manual Ior Normal For rolled Hemming

Page 31

®®

		Regular		Rolled	her'nm_ng
		(ior	normal	(for rolled		hemming
		Sewing}		p_cot	edging	and
				narrow	hemming)
Stamp	on	the reverse	"S ....		R"
stde ol	the	plate

"Select the needle plate for your sewing need.

*Your overlock is shipped with the regular needle plate in place,

For your Safety:

When you change the needle plate or adjust the seam width, make sure that the machine is discon* nected from the power supply.

=:

::[::

,::::{:: ': ::::

:::::'::}:

: ::::::,:::::"

Tighten

N eedIe

Be[ Screw

(_) Turn the hand wheel toward you until the

needle comes above the needle plate. Then remove the presser foot.

(_ Open the side and looper covers. (Refer to page 6.)

®Set the upper knife to down posrtion. (Refer to page 29.)

@Remove the needle plate set screw, and lift the needle plate.

@Attach the needle plate you require with the needle plate set screw,

(_) Bring the upper knife to up position. (Refer to page 29.)

(_ Close the looper and side covers,

(_) Attach the presser foot.

30

Image 31

Contents

Overlock 3j4 Kenmore Overiock Ofcontents Carrying handle Stitch tength Thread guide bar Face plate Presser foot lifter Safety Feature Eel Alwaysturnhandwheeltowardyou LOI Raising = ,.oT L,,.o=,,werin=.g=thePresser=., .. Foot,= Located behind tooper cover OranoGutde How to Thread the Lower LooperThread Lower looperThreading the Upper Looper Toopethread Threading the Needle on the Right Insert Thread between tension discs from Thread gutde plate Needle thread Ension dial Lever thread Thread take-up guide Iiii!iit Thread Securing Ends Turn the fabric over so that the under sIde is up Lower Correct TensionThread tension Wrong Tension Thread Tension AdjustmentTension Read Is looseFor narrow three-thread Sergmg Using the Needle on Right OnlyWrong Tension Wrong Tenston Top of the machine Decrease\ To increase IiRemoving the PresseFoot Rl o To Disengage the Upper Knife Ior Normal For rolled Hemming Limng Lght wetght Medium weight Heavy weight KnitsPlate Roiled HemmingPicot Edging Narrow HemmingFabric SettingRolled Hemmtng Picot Edging Picot Adjusting Thread TensionTwist Thread, Fabric MediumLight Fabric Thread$8 SCreW Protect your fingers when you handle it Disconnect the machine from the power supply before oiling Jpper Reference NeattySeam DoesParts List Index Specification of the Machine Overlock