\\
0.5 _tmm {]/32"'} | /_Jpper |
Lower
knife
To | Remove: |
|
|
| To | Attach: |
|
|
|
|
|
| |
(_) | Disconnect | the | machine | trom the power supply. | insert | new | upper knife | into | the groove of | knife | |||
(_ | Open | the | looper | and | side | covers. | holder | and | stopper | pro, | then | tighten | the |
hexagon | bolt slightly. |
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
| |||
1_ | Disengage | the upper | knife. |
|
|
|
|
|
|
| |||
| (Refer | to | page | 29.) |
|
|
|
|
|
|
|
|
|
(_) Remove the hexagon bolt, and remove the upper knife.
"The lower knife wilt last over one year in normal use. However, if you run over a pin or a hard object, it may at the same time.
(_) Turn the upper knife holder to cutting position.
(_) Turn the hand wheel toward you until the upper knife comes to its lowest position.
Loosen the hexagon bolt, and adjust the posi- tion of upper knife so that the edge of the upper knife overlaps 0.5 to 1 mm (1/32"} from the edge of lower knife as shown above.
Then tighten the hexagon bolt firmly.
(_} Close the looper and side covers,
be required to replace both upper and lower kmves
4O