White 1000 instruction manual Inserting, Shuttle Race, Changing Needle, Bobbin Case Into

Page 12

7

INSERTING

BOBBIN CASE

INTO

SHUTTLE

RACE

nse

If

	Hinged		latch
	Hinged
							—I
1.	Ensure	needle		is	at its	highest	position.
	Pulling	thread		to the		front,	open the
	latch of	bobbin			case and hold		it.

2.

Holding		latch open,			piace	bobbin case
onto	centre		pin	in	shuttle	and release
latch.

CHANGING

NEEDLE

1. 2.

3.

4.

Raise	needle		to	its highest			.
						position
Loosen		needle		clamp	screw	and re

			.
move old needle
With	the	flat	side of the needle				facing

away	from you,			insert	needle	as	far up
as it will		go.
Tighten		the	needle		clamp		screw

securely.

Note:
At	the

first

sign

of

any

stitching

irregularity	always	change
a new good	quality	one.

the

needle for

13

Image 12

Contents White Precautions Should Be left unattended when pluggedCleaning Operate where aerosol spray productsPlugs Name of Parts Accessories Removing the extension table Conte NTSName of Parts Front Side ThumbscrewAccessori ES #11REMOViNG Extension Before Sewing By the speed controllerFitting of Presser Feet Fitting Shank QuiltingGuide Winding Bobbin Removing Bobbin Case and Bobbin Inserting BOBBiN Into Bobbin CaseInserting Shuttle RaceChanging Needle Bobbin Case IntoThreading ThreadUpper Down behndChanging DirectionsDrawing Bobbin RotateAdjusting Upper Thread Tension TurningCorrect Wound bobbinRegulating Presser Foot Pressure FeedDrop DirectonFabric Needle GuidePattern Selector Operation Table Patterns SetchHce Pattern Selector Operation Table Start FinishSeam Straight ZIG-ZAGStitch Blind HemmingThree Step ZIG-ZAG Overcasting Edges BindingStraight Stretch Stitch TripleSewing on Buttons Sewing Zips Button Hole Sewing User TipsHemming Freehand Embroidery TwinCleaning ShuttleRace HookCz c Remedy