CARING FOR THE MACH NE ................................................................................................
CLEANING AND OILING
Fig. 1 Cleaning the feed dogs with a brush.
To insure the best possible operation of your machine, it is necessary to keep the essential parts clean at all times. Using a small brush, remove the lint that accumulates in the shuttle
area and around the feed dogs.
Fig. 1
Fig. 2 Parts of the Shuttle Assembly
To Clean the Shuttle Area:
1.This area must be kept free of dust, lint and occasional tangled thread. Raise the needle bar to its highest point and remove the bobbin case.
,
.
.
Push levers of shuttle race aside and lift shuttle race cover and shut- tle out.
Clean the shuttle race with small brush,
Put a drop of oil on the center pin of the shuttle and shuttle race.
(see arrows)
To Replace Shuttle Assembly-
1.Position shuttlerace as illUStrated so
that shuttle driver is forming half moon on the left side of the
machine.
. Hold shuttle by center pin and position shuttle so as to form a half
moon on the right side, Pointed hook will be on the bottom.
=Place shuttle race cover into place over shuttle assembly.
43