Pella 81470102 installation instructions 7INSTALLING Interior Jamb Cove Mould

Page 11

NEW CONST NEW CONST

L. Insert backer rod and apply sealant. Install siding, and insert backer rod between the each jamb cover and the exterior finish material as deep as it will go. Apply a bead of high quality exterior sealant on top of the backer rod and a corner bead to the top of the head frame expander. Shape, tool, clean excess sealant. When finished, the sealant should be the shape of an hourglass.

Note: Backer rod adds shape and depth for the sealant line. This method creates a more flexible sealant line capable of expanding and contracting.

7INSTALLING INTERIOR JAMB COVE MOULD

ALL ALL ALL ALL ALL ALL

A.Install the interior cove mould. Remove cove mould from accessory package and dry fit over the installation screws. Install interior cove mould and secure with 1" brads into the jamb and trim.

Cove Mould

Image 11

Contents Cable clamps Jamb covers Remove all packaging from the window Replacement Applications Remove1ROUGH Opening Preparation Remember to USE Appropriate Personal Protective EquipmentSiding 2PREPARING and Setting the Window TWO or More People will be Required for the Following Steps 3CABLE Clamp InstallationRun the cable up through the bottom of the cable clamp Cross Bracing Mount NON Accessible Cable AttachmentInstall 2 x 6 cross braces between the rafter Cross Bracing Mount of Cable ClampsRun the cable up through the bottom Supporting the WindowHeader Mount of Cable Clamps Remove blocking from under the seat boardApply insulating foam sealant. From the interior 5INSULATING Foam ApplicationAngle Jamb Cover Vinyl Siding Replacement Wood Siding Replacement6SEALING the Window to the Exterior Wall Cladding If using Square Jamb Cover, Proceed to CIf using Angle Jamb Cover, Proceed to G Cove Mould 7INSTALLING Interior Jamb Cove MouldExterior Finish Care and Maintenance Important NoticeInterior Finishing