3CABLE Clamp Installation

2PREPARING AND SETTING THE WINDOW (CONTINUED)

ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL

TWO OR MORE PEOPLE WILL BE REQUIRED FOR THE FOLLOWING STEPS

B.Insert the window from the exterior of the building. Place the seat of the window at the bottom of the opening and slide the top into position. Center the window between the sides of the opening to allow clearance for shimming.

Note: If cross bracing is required for soffit installation of the cable systems, proceed to Step 3A and install cross bracing before unit is inserted into the rough opening.

C. Place temporary bracing under the seat of the

window to raise the unit level.

D. Place a shim near the top of the one jamb board, aligned with the top pre-drilled hole in the jamb board. Drill a pilot hole and partially insert a #10 x 3" flat head screw provided. Repeat for the other jamb.

E. Continue placing shims at each pre-drilled installation screw hole in the jamb boards to plumb and square the window. Check window for squareness by making sure diagonal measurement for corner to

corner is within 1/8" in both directions. Insert a #102C x 3" flat head wood screw into each pre-drilled hole in

the jamb boards. Finish inserting the top screw in each jamb board.

Interior	Interior
2E	2E

F.If desired, shim and fasten headboard to rough opening. To keep plywood straight, center one finish head screw or 10D finish nail on units less than 10 feet wide and equally space two fasteners on units wider than 10 feet.

Cross bracing mount

ALL ALL ALL ALL ALL ALL ALL

Note: Support cables are installed in factory assembled bay and bow combinations.

T-nut

Install Cable Clamps based on type of installation needed. Cross Bracing Installation consists of attaching 2 x 6 cross bracing between the rafter tails. Header Mount Installation consists of attaching to a solid structural member - header, sill plates or wall stud.

Header

mount