Pella 81470102 installation instructions 2PREPARING and Setting the Window

Pella 81470102 installation instructions Cable clamps Jamb covers Pella 81470102 1ROUGH Opening Preparation, Remember to USE Appropriate Personal Protective Equipment Pella 81470102 installation instructions Siding Pella 81470102 installation instructions 2PREPARING and Setting the Window Pella 81470102 3CABLE Clamp Installation, TWO or More People will be Required for the Following Steps Pella 81470102 Cross Bracing Mount of Cable Clamps, Cross Bracing Mount NON Accessible Cable Attachment Pella 81470102 Supporting the Window, Header Mount of Cable Clamps, Remove blocking from under the seat board Pella 81470102 installation instructions 5INSULATING Foam Application, Apply insulating foam sealant. From the interior Pella 81470102 installation instructions Angle Jamb Cover, Vinyl Siding Replacement Wood Siding Replacement Pella 81470102 6SEALING the Window to the Exterior Wall Cladding, If using Square Jamb Cover, Proceed to C Pella 81470102 installation instructions 7INSTALLING Interior Jamb Cove Mould Pella 81470102 installation instructions Interior Finishing, Exterior Finish, Care and Maintenance Important Notice
Page 4

1ROUGH OPENING PREPARATION (CONTINUED)

ALL ALL ALL ALL ALL ALL ALL

J.Apply sill flashing tape #2. Cut a piece of flashing tape 12" longer than the opening width. Apply at the bottom, overlapping tape #1 by at least 1". DO NOT allow the tape to extend past the interior face of the opening.

Note: The flashing tape may not fully cover the framing members.

K.Install and level sill spacers. Place 1" wide by 3/8" thick spacers on the bottom of the opening 1" from each side and every 16" on center. Add shims as necessary to ensure the spacers are level. Once level, attach spacers and shims to prevent movement.

1J

1K

2PREPARING AND SETTING THE WINDOW

ALL ALL ALL ALL

If using Square Jamb Cover , Proceed to Step 2A.

If using Angle Jamb Cover , Proceed to Step 2B.

Square Jamb Cover

Angle Jamb Cover

ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL ALL

A.Install exterior jamb covers. Apply sealant along the leg of the jamb frame cover(s). Apply a bead of sealant to the top corner of the bottom frame expander. Drive the short leg of the jamb frame cover into the accessory groove using a block of wood with rounded edges and a hammer. The notched end of the jamb cover goes toward the sill.

Sealant Bead - Along Flange

Square Jamb Cover

Sealant along leg of

Square Jamb Cover

Notched end of Square

Jamb Cover

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Cable clamps Jamb covers Replacement Applications Remove 1ROUGH Opening PreparationRemember to USE Appropriate Personal Protective Equipment Remove all packaging from the windowSiding 2PREPARING and Setting the Window 3CABLE Clamp Installation TWO or More People will be Required for the Following StepsCross Bracing Mount NON Accessible Cable Attachment Install 2 x 6 cross braces between the rafterCross Bracing Mount of Cable Clamps Run the cable up through the bottom of the cable clampSupporting the Window Header Mount of Cable ClampsRemove blocking from under the seat board Run the cable up through the bottom5INSULATING Foam Application Apply insulating foam sealant. From the interiorVinyl Siding Replacement Wood Siding Replacement Angle Jamb CoverIf using Angle Jamb Cover, Proceed to G If using Square Jamb Cover, Proceed to C6SEALING the Window to the Exterior Wall Cladding 7INSTALLING Interior Jamb Cove Mould Cove MouldInterior Finishing Care and Maintenance Important NoticeExterior Finish
Top Page Image Contents