Installing GAS LOG Heater Into Stove

INSTALLATION

Stove Cavity Assembly (Cont.) Installing Gas Log Heater Into Stove

INSTALLATION

Continued

CAUTION: Do not remove the data plates attached to the heater base assembly. The data plates contain important warranty and safety information.

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs accord- ing to the log installation instructions in this manual. Flames contacting logs will create soot.

7.Fasten heater base to stove bottom with #10-24 x .50 bolts and hex nuts provided with gas log heater (see Figure 16). Attach- ment hardware is factory packed inside plastic bag with instal- lation manual and owner’s registration card. Push bolt through heater base mounting hole and through stove bottom. Connect hex nut to bolt on underside of stove bottom. The bolt hex head is for a 5/16" socket and the hex nuts are for a 3/8" socket. If sockets are not available, use adjustable wrenches.

8.Set one-piece log on heater base as shown in Figure 17. Make sure middle section at bottom of log is seated into "U" shaped cutout in center of heater base. Log will fit securely on base. IMPORTANT: Make sure log does not cover any burner ports and does not touch the stove cavity (see Figure 18).

9.Fasten back panel to stove with six (6) M6 x 1.20mm bolts and washers. Make sure product identification label is located on the outside lower left-hand corner.

10.Place freestanding stove in desired position in room. Be sure to maintain clearances to combustibles as outlined on page 7.

1.Remove log and gas log heater from carton. Note: Do not pick up gas log heater by the burner itself. This could damage heater. Always handle the gas log heater by the heater base only.

2.Remove all protective packaging applied to log and gas log heater for shipment.

3.Check all items for any shipping damage. If damaged, promptly inform dealer where you bought heater.

Bolt				Heater Base

Hex Nut

Stove Bottom

Figure 16 - Fastening Heater Base to Stove Drop Bottom

4.If not already removed, remove back panel from assembled stove body (see Figure 5, page 8). Use an adjustable wrench or a 10 mm socket. Remove six (6) bolts and washers. Keep bolts and washers to reattach back panel later.

5.Set gas log heater inside stove. Make sure control knob extension passes through bottom front opening (see Figure 15).

6.Align outside holes on heater base with four (4) mounting holes on the stove bottom (see Figure 15).

One-Piece

Log Set