Enviro CE2005 owner manual Introduction, USE of Cordwood is Prohibited by LAW

Page 3

Introduction

IMPORTANT SAFETY DATA:

Please read this entire manual before installation and use of this pellet fuel burning room heater. Failure to follow these instructions could result in property damage, bodily injury or even death.

CAUTION: DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM.

DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS SUCH AS GASOLINE, NAPTHA OR ENGINE OIL.

UNIT HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN BURNS.

Contact local building officials about restrictions and installation inspection requirements in your area.

The stove’s exhaust system works with negative combustion chamber pressure and a slightly positive chimney pressure. It is very important to ensure that the exhaust system be sealed and airtight.

The use of grates or other methods of supporting the fuel is not permitted.

This unit is designed to burn pelletized wood fuel only. Do not use any other type of fuel, this will void any warranties stated in this manual.

THE USE OF CORDWOOD IS PROHIBITED BY LAW.

Do not burn with insufficient combustion air. A periodic check is recommended to ensure proper combustion air is admitted to the combustion chamber. Setting the proper combustion air is achieved by adjusting the slider/damper located on the left side of the stove.

It is advisable to clean the exhaust vent bi-annually or every two tons of pellets.

The grounded electrical cord should be connected to a standard 220-240 volts, 50 hertz electrical outlet and also must be accessible. If this power cord should become damaged, a replacement power cord must be purchased from the manufacturer or a qualified ENVIRO dealer. Be careful that the electrical cord is not trapped under the appliance and that it is clear of any hot surfaces or sharp edges. This unit’s maximum power requirement is 800 watts (3.3 amp).

Soot or creosote may accumulate when the stove is operated under incorrect conditions such as an extremely rich burn (black tipped, lazy orange flames). If the creosote is ignited it will make an extremely hot fire, therefore, the smoke pipe and chimney should be inspected regularly to determine if a build-up has occurred. If creosote has accumulated it should be removed to reduce the risk of a chimney fire. If a fire occurs throw a cup of water into the firebox, close the door, and call the fire department.

When installing the stove in a mobile home, it must be electrically grounded to the steel chassis of the home and bolted to the floor. Make sure that the structural integrity of the home is maintained and all construction meets local building codes.

Be sure to maintain the structural integrity of the home when passing a vent through walls, ceilings, or roofs.

IMPORTANT: The ash pan and viewing door must be locked securely for proper and safe operation of the pellet stove.

If you have any questions with regards to your stove or the above-mentioned information, please feel free to contact your local dealer for further clarification and comments.

Since Sherwood Industries Ltd. has no control over the installation of your stove, we grant no warranty implied or stated for the installation or maintenance of your stove. Therefore, Sherwood Industries Ltd. assumes no responsibility for any consequential damage.

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents EF Thermo Table of Contents USE of Cordwood is Prohibited by LAW IntroductionPellet Quality is IMPORTANT, Please Read the Following Store pellets at least 36 1 m away from the pellet stove Rating label is located on the hopper lid ON/OFF Button Operating InstructionsAuger Trim Convection Blower ControlTurning OFF Your Pellet Stove ASH Removal Routine Cleaning and MaintenanceASH PAN and Door Gaskets Pellet Fuel in ASH PANASH PAN Post Season CLEAN-UPASH Drawer Do not Place Unburned or RAW Pellet FuelHeat Exchanger and Internal Exhaust Tubes Stove will not start TroubleshootingStove will not operate when hot Control settings Heat Level have no effect on the fireStove keeps going out Stove will not shut offWarranty To the DistributorFor the do-it-yourself Individual Name of Owner Address Installation Data Sheet

CE2005 specifications

The Enviro CE2005 is an advanced environmental monitoring and management system, designed to address a wide array of ecological challenges. It serves as a versatile tool for agencies, organizations, and individuals who seek to enhance their environmental practices. At its core, the CE2005 leverages cutting-edge technologies to deliver real-time data and analytics that are critical for informed decision-making.

One of the standout features of the Enviro CE2005 is its integrated sensor framework. This system is equipped with a variety of sensors that monitor key environmental parameters such as air quality, water quality, soil moisture, temperature, humidity, and noise levels. These sensors transmit data wirelessly to a central hub, ensuring that users have access to the most current information at their fingertips. This feature is particularly beneficial for environmental scientists and researchers working in the field, as it eliminates the need for manual data collection and provides immediate insights into environmental conditions.

Another key characteristic of the CE2005 is its user-friendly interface. The system is equipped with a sophisticated yet intuitive software platform that allows users to easily navigate through data layers, visualize trends, and generate comprehensive reports. Users can customize dashboards based on specific monitoring needs, making it simple to highlight critical metrics. This capability enhances the overall user experience and enables stakeholders to quickly identify emerging issues and take proactive measures.

In terms of data analytics, the Enviro CE2005 employs advanced algorithms and machine learning techniques to process and interpret environmental data. This allows users to identify patterns, forecast trends, and make predictions about future environmental scenarios. The predictive capabilities of the system are particularly useful for urban planners and environmental policy makers who need to assess the potential impact of proposed developments or changes in land use.

Additionally, the CE2005 is designed with sustainability in mind. It operates on an energy-efficient architecture that minimizes its environmental footprint. The system is compatible with renewable energy sources, making it an eco-friendly choice for monitoring programs in remote or off-grid locations.

Overall, the Enviro CE2005 is a comprehensive environmental monitoring solution that combines innovative technologies with practical features. Its integrated sensor framework, user-friendly interface, advanced data analytics, and commitment to sustainability make it an invaluable asset for anyone dedicated to preserving and enhancing the environment. Whether for research, policy-making, or community awareness, the CE2005 provides the tools necessary to tackle the pressing environmental challenges of our time.
Top Page Image Contents