Enviro CE2005 Operating Instructions, Auger Trim, Convection Blower Control, ON/OFF Button

	Operating Instructions
CONTROL BOARD FUNCTIONS:
			1. WATER TEMPERATURE DIAL: Read in degrees Celsius
			2. AUGER TRIM
	
	
		�	3. CONVECTION BLOWER CONTROL
			4. AUGER PULSE LIGHT: The light flashes in conjunction with
			the auger.
			5. MANUAL AUGER FEED: If the unit runs out of fuel, this
			button can be used to “prime the auger system”. This button
			will turn off after 60 seconds and then must be released and
	 		pressed again.
		�	6. SYSTEM LIGHT: If flashing, the board is under control. If
			the light is solid, setting can be altered.
�		�	7. ON/OFF BUTTON
	
		�	8. HEAT OUTPUT INDICATOR: Shows the present heat
		�
	 		output setting.
		�	9. HEAT LEVEL ADJUSTMENT: When pressed, will change
�		�	the heat setting of the unit from low to high.
 
			NOTE: This unit is capable of continuous operation if the heat
			demand is high enough to require the unit to stay on.
Figure 3
TURNING PELLET STOVE ON:

Ensure the hopper has sufficient pellet fuel to start the unit.

1.Set water temperature, using the rotary dial located above the feed controls.

2.Press the ON / OFF button to start the appliance. System light will flash, auger light will flash with the pulse of the auger, heat level indicator will show the start up heat setting with no control for the operator until the system light becomes solid.

3.If this is the first time the unit has been started or the unit has run out of fuel, press the Manual Auger Feed button and hold down for 60 seconds. This will help “prime the auger,” deliver fuel to the burn pot, and help light the unit more quickly.

4.When a fire has been established, the system light will become solid and the auger light will continue to flash. The heat output button can be pressed to achieve the desired heat setting.

7