Enviro EF-119 owner manual Or from the outside of the pedestal for the FPI or BIH

Page 14

Installation

CLEARANCES TO COMBUSTIBLES - BUILT-IN HEATER:

Refer to Figures 10 and 11.

 

 

Side wall to unit

- 8 inches

(20.3 cm)

Mantel projection

- 10 inches

(25.4 cm)

Mantel to top of unit

- 8 inches

(20.3 cm)

Top facing to unit

- 8 inches

(20.3 cm)

Side facing to unit

- 6 inches

(15.2 cm)

Floor protection

- 6 inches

(15.2 cm)

(on either side and to the front

must be protected

by non-combustible material)

 

 

Sides and rear walls to standoffs:

- 0 inches

(0 cm)

Recess depth:

- 11 inches

(30 cm)

 

33"

 

(84 cm)

 

12"

 

(30.5 cm)

 

30"

 

(76 cm)

 

6"

 

(15 cm)

6"

Floor Protection

(15 cm)

Figure 11: EF2 Built-In Heater recommended

framing.

PEDESTAL INSTALLATION:

The all models comes with a pedestal that has to be attached prior to installation:

• Remove the unit from the box

• Remove the freestanding pedestal from the box. Remove the FPI or BIH pedestal from the hopper.

Figure 13: Fireplace Insert Pedestal.

Figure 12: Freestanding Pedestal.

• Place the unit on its back on the pallet.

• Back the four (4) 5/16” hex head screws in the base off three (3) to four (4) full turns.

• Align the keyholes in the pedestal with the screws, lock into place.

•Secure the two (2) pieces by tightening the four (4) screws from the inside of the pedestal for the freestanding

or from the outside of the pedestal for the FPI or BIH.

Figure 14: Built-In Heater Pedestal.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents EF2 Table of Contents Store pellets at least 36 1 m away from the pellet stove IntroductionI. Pellet Standards USE of Cordwood is Prohibited by LAW Keep ASH PAN Free of RAW Fuel Special Notes Reasons WHY the Unit OverheatedOperating Instructions Special Notes Burn POT and Liner 2-3 days Routine Cleaning and MaintenanceTools Required to Clean Unit Inside Firebox 2-3 daysFireplace Insert and BUILT-IN Heater ASH PAN Not Place Unburned or RAW Pellet Fuel in ASH PANFreestanding ASH PAN Brick Panel Post Season CLEAN-UPCleaning Plated Surfaces Installation Screws to take out to remove stove from palletDimensions of EF2 Freestanding Minimum Alcove width Inches 91 cm Minimum Alcove height Or from the outside of the pedestal for the FPI or BIH EF2 Built-In Heater recommended FramingVent surfaces can Fresh AIR Intake ExhaustFreestanding Fireplace Insert Built-In Heater Fresh Air Intake Unit on it Locate the center of the exhaust Is the recommended installation set up Inside Vertical Installation Install the hearth pad Freestanding hearth mount installation overview Connect a tee or 90 degree This unit includes a 3 75 mm pedestal Corner Brackets Removal Side surround panel swings forwardStove will not light TroubleshootingStove will not start Convection blower will not function normally Stove will not function in the Auto mode when hotExhaust motor will not function normally Auger motor will not function normally Stove will not shut off Dial-a-fire has no effect on the firePotentiometer Readings Stove keeps going outWiring Diagram Parts List Fireplace Insert Stove Top Parts List Parts List Options ComponentsDPartsiagram Parts Diagram Steel To the Distributor WarrantyTo the Dealer Installation Data Sheet Name of Owner Address

EF-119 specifications

The Enviro EF-119 is an innovative, environmentally friendly vehicle that has garnered attention for its advanced technology and impressive performance characteristics. Designed with sustainability in mind, the EF-119 incorporates cutting-edge features that make it a standout choice in the green vehicle market.

One of the main highlights of the Enviro EF-119 is its electric powertrain. The vehicle is equipped with a high-capacity lithium-ion battery that offers a range of up to 300 miles on a single charge, making it ideal for both urban commuting and longer journeys. The EF-119 also features fast charging capabilities, allowing drivers to recharge their batteries to 80% in just under 30 minutes with compatible charging stations, significantly reducing downtime during travel.

In terms of design, the EF-119 boasts a sleek, aerodynamic shape that not only enhances its visual appeal but also improves energy efficiency. The vehicle's lightweight chassis is constructed from advanced composite materials, reducing overall weight while maintaining structural integrity. This design decision contributes to lower energy consumption and improved handling on the road.

The EF-119 comes equipped with an array of smart technologies that enhance the driving experience. An intuitive infotainment system offers seamless connectivity with smartphones and other devices, allowing drivers to access navigation, music, and communication apps effortlessly. Additionally, the vehicle includes advanced safety features, such as adaptive cruise control, lane-keeping assist, and a comprehensive suite of sensors that provide real-time data on the vehicle's surroundings, ensuring a safe and comfortable ride.

Another notable characteristic of the Enviro EF-119 is its regenerative braking system. This technology captures energy typically lost during braking and redirects it back into the battery, enhancing overall efficiency and extending the vehicle's range. The result is a more sustainable driving experience that reduces wear on traditional braking systems.

Overall, the Enviro EF-119 represents a significant step forward in the evolution of electric vehicles. With its impressive range, advanced safety features, and commitment to sustainability, it meets the needs of modern drivers who prioritize eco-friendly transportation without compromising on performance or style. As the automotive industry shifts towards greener alternatives, the EF-119 stands out as a leading choice for environmentally conscious consumers seeking innovation and excellence.
Top Page Image Contents