Enviro 50-1574 technical manual Minimum Alcove height 1220mm

Page 8

Installation

CLEARANCES TO COMBUSTIBLES:

This unit can be installed on a combustible floor when installed with the optional hearth pad part 50-1568 (for example linoleum, hardwood flooring). If this unit is to be installed onto a carpeted surface, a hearth pad must be used for stability.

 

Back Wall

4"

 

4" (10cm)

 

(10cm)

Wall

 

 

Side

77/8"

 

(20cm)

 

 

 

Figure 3: Evolution Clearance to Combustibles.

These dimensions are minimum clearances but it is recommended that you ensure sufficient room for servicing, routine cleaning and maintenance.

Side wall to unit

200mm

(77⁄8 inches)

Back wall to unit

100mm

(4 inches)

Corner to unit

100mm

(4 inches)

In Front of unit

800mm

(311⁄2” inches)

ALCOVE CLEARANCES:

This unit may be installed in an alcove. Maintain these clearances to combustibles.

Minimum Alcove width

1220mm

(48 inches)

Minimum Alcove height

1220mm

(48 inches)

Maximum Alcove depth

1220mm

(48 inches)

Install vent at clearances specified by the vent manufacturer.

48"

(122cm)

48"

(122cm)

48"

(122cm)

Figure 4: Evolution Minimum Alcove Size.

8

Image 8
Contents Evolution Table of Contents Safety Warnings & Recommendations Safety Warnings & Recommendations Safety Warnings & Recommendations Installation Screws to take out to remove stove from palletImportant When not installing Minimum Alcove height 1220mm Installing Hearth Pad Pedestal onto Evolution Letter Minimum Clearance Description Exhaust Starter Tube can be installed 2 ways Exhaust LocationFresh Air Intake Airflow around the structure Venting horizontally with rise Inside Vertical Installation Outside Vertical Installation Through vent hole Exterior Blower KitThrough Wall Installation with Exterior Blower Kit EF5 NEW Zealand Special Notes Stove will not start TroubleshootingStove will not operate when hot Light # 2 on Heat output bar flashing 93C 200F high limit temperature sensor has trippedExhaust motor will not function normally Control settings Heat Level has no effect on the fire Convection blower will not function normallyIgnitor- the pellets will not light Stove keeps going outWiring Diagram Parts List Reference # DescriptionParts List Parts Diagram Components Parts Diagram Steel Installation Data Sheet Name of Owner Address