Enviro 50-1266, C-11112 owner manual Keep ASH PAN Free of RAW Fuel

Page 5

Introduction

ASHES: Disposed ashes should be placed in a metal container with a tight-fitting lid. The closed container of ashes should be on a non-combustible floor on the ground, well away from all combustible materials pending final disposal. The ashes should be retained in the closed container until all cinders have thoroughly cooled before disposing of them.

ELECTRICAL: The use of a surge protected power bar is recommended. The unit must be grounded. The grounded electrical cord should be connected to a standard 120 volts, 60 hertz electrical outlet and also must be accessible. If this power cord should become damaged, a replacement power cord must be purchased from the manufacturer or a qualified ENVIRO dealer. Be careful that the electrical cord is not trapped under the appliance and that it is clear of any hot surfaces or sharp edges. This unit’s maximum power requirement is (4.1 Amps) 500 watts.

GLASS: Do not abuse the glass by striking or slamming the door. Do not attempt to operate the stove with broken glass. The stove uses ceramic glass. Replacement glass must be purchased from an ENVIRO dealer. Do not attempt to open the door and clean the glass while the unit is in operation or if glass is hot. To clean the glass, use a soft cotton cloth and mild window cleaner, gas or wood stove glass cleaner, or take a damp paper towel and dip into the fly ash. This is a very mild abrasive and will not damage the glass.

FLAMMABLE LIQUIDS: Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or “freshen up” a fire in the heater. Keep all such liquids well away from the heater while it is in use.

SMOKE DETECTOR: Smoke detectors should be installed and maintained in the structure when installing and operating a pellet burning appliance.

OPERATION: The ash pan and door must be closed securely for proper and safe operation of the pellet stove. Also ensure all gaskets on the door are checked and replaced when necessary.

KEEP ASH PAN FREE OF RAW FUEL.

DO NOT PLACE UNBURNED OR NEW PELLET FUEL IN ASH PAN. A fire in the ash pan may occur.

If you have any questions with regards to your stove or the above-mentioned information, please feel free to contact your local dealer for further clarification and comments.

SINCE SHERWOOD INDUSTRIES LTD. HAS NO CONTROL OVER THE INSTALLATION OF YOUR STOVE, SHERWOOD INDUSTRIES LTD. GRANTS NO WARRANTY IMPLIED OR STATED FOR THE INSTALLATION OR MAINTENANCE OF YOUR STOVE. THEREFORE, SHERWOOD INDUSTRIES LTD. ASSUMES NO RESPONSIBILITY FOR ANY CONSEQUENTIAL DAMAGE(S).

SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Empress Table of Contents Store pellets at least 36 1 m away from the pellet stove IntroductionUSE of Cordwood is Prohibited by LAW Keep ASH PAN Free of RAW Fuel Empress Dimensions SpecificationsSpecial Notes Slider / Damper Must be SET AT Time of InstallationOperating Instructions Heat Level Adjustment When Heat Output Indicator ShowsInitial START-UP See above Thermostat / Switch ModeTools Required to Clean Unit Routine Cleaning and MaintenanceDoor Glass Cleaning When needed Burn POT and Liner 2-3 daysDo not Place Unburned or RAW Pellet Fuel in ASH PAN Cleaning Surfaces Post Season CLEAN-UPFirebox Panel Replacing Door GlassFor the do-it-yourself Individual WarrantyTo the Distributor Name of Owner Address Installation Data Sheet

C-11112, 50-1266 specifications

Enviro 50-1266, also known by its designation C-11112, is a cutting-edge product that stands out in the realm of environmentally friendly solutions. It is designed with a focus on sustainability while delivering high performance in various applications. One of its main features is its biodegradable composition, which significantly reduces environmental impact compared to traditional products. This aspect appeals to both consumers and businesses looking to adopt greener practices.

The product is formulated using advanced technologies that enhance its effectiveness. One of these technologies involves the incorporation of bio-based materials that exhibit exceptional durability and resistance to degradation. This ensures that the product maintains its integrity over time, even in challenging environments, while still being safe for the ecosystem.

Furthermore, Enviro 50-1266 features a unique formulation that allows for versatile usage across different sectors, from agriculture to industrial applications. Whether used as a cleaner, lubricant, or in manufacturing processes, its performance remains consistent and reliable. Additionally, the product is designed to be user-friendly, facilitating easy application without the need for specialized equipment or extensive training.

Another noteworthy characteristic of Enviro 50-1266 is its non-toxic nature, making it suitable for use around children and pets. This feature broadens its appeal, particularly among environmentally conscious consumers and organizations. The product not only meets but often exceeds regulatory standards for safety and environmental compliance, further establishing its credibility in the market.

In terms of customer support, the manufacturers provide comprehensive resources, including detailed guidelines for optimal use and applications. They also offer responsive customer service to address any inquiries or concerns, which enhances the overall user experience.

In summary, Enviro 50-1266, C-11112, is a versatile, sustainable solution that excels in various applications while prioritizing environmental responsibility. Its biodegradable composition, advanced manufacturing technologies, and user-friendly characteristics make it a notable choice for those seeking effective and eco-friendly alternatives. With a commitment to safety and compliance, this product not only meets modern demands but also contributes positively to the preservation of our planet.
Top Page Image Contents