Amana ACF422GA, ACF4225A Self-cleaning, Do I need to prepare?, Interrupting the self-clean cycle

Using the Oven Control (cont’d)

Self-cleaning

Self-clean feature uses high oven temperature to clean oven interior. For the oven to operate through a complete self-clean cycle, the self-clean must be set when the oven is cool.

1.Prepare oven for self-cleaning (see below right). Oven bottom recess must be checked for grease build up before beginning a self- clean cycle. See Care and Cleaning.

2. Close door.

3. Push and turn oven temperature knob to CLEAN position.

• The default self-clean cycle length of 3 hours will display.

4. Set cycle length for self-clean.

• Use arrow keys to adjust time as necessary before oven indicator light turns on.

• Clean cycle can be set from two to four hours in five minute increments.

•Default setting for the cycle is three hours.

5.Self-clean begins.

•OVEN ON indicator light will be on and will remain on until the end of the cycle.

•At the end of the self-clean cycle, the OVEN ON indicator light will shut off.

•At the end of the self-clean cycle, the oven will stop heating, however, oven will remain hot.

•The LOCKED indicator light will remain on until oven reaches a cooler temperature. LOCKED light will flash while door is unlocking, and then shut off when door has unlocked. Oven cavity will be hot to the touch. DO NOT attempt to open door prior to LOCKED indicator light shutting off. When oven is cool, turn oven knob to OFF.

Interrupting the self-clean cycle

To stop a self-clean cycle that has already started follow these steps. If the interruption occurs mid cycle, the oven will remain locked, even though the cycle has stopped, until the oven cavity has cooled to a lower temperature.

1.Turn oven temperature knob to OFF position.

2.When oven has cooled to a lower temperature, LOCKED light turns off. Door can be unlocked. DO NOT force door.

This can cause damage to the latch.

!CAUTION

To avoid fire or smoke damage,

•remove any flammable materials from storage drawer. Items like plastic containers and paper manuals can melt or burn.

•clean excess spills before starting a self-clean cycle.

!WARNING

To avoid risk of personal injury, do not touch oven vents, or area around vents, during self-cleaning. These areas can become hot enough to cause burns.

!WARNING

To avoid risk of personal injury, property damage, or fire, clean excess grease and soil from oven before beginning a self- clean cycle.

Do I need to prepare?

To get the best results from the self-clean cycle, follow these steps:

•Clean excess spills from oven interior and bottom thoroughly.

•Remove birds or animals susceptible to smoke or other fumes from the room or adjoining room.

•Open window if possible.

•Make sure oven light cover is properly in place. Do not use cleaning cycle if it is not.

•Remove oven racks and all cooking utensils from oven.

•Remove items from range top, backguard and storage drawer. These areas can become hot during self-cleaning cycle.

•The range vents from the center bottom of the backguard. Make sure this area is unobstructed by removing all items from backguard and range top.

15