Avalon Stoves Avanti PS manual Operation1, Loading Pellets, Two Modes of Operation

Page 19

Operation1 7

Loading Pellets

Lift the hopper lid to its vertical position. Pour pellets into the hopper until full. NOTE: The hopper holds approximately 55 pounds of pellets.

WARNING:

The front edge of the hopper lid becomes very hot, do not touch the area below the handle.

e

lle

P

Make sure pellets are not left on this heat shield.

ts

The Two Modes of Operation:

Manual

Manual mode requires the user to turn the heater on and off manually.

Auto (requires a thermostat)

Auto mode allows you to use a thermostat to control room temperature. The stove automatically turns on when the temperature drops below the thermostat setting. Once the stove reaches operating temperature, the stove then runs at the heat output setting selected.

Switching Modes While in Operation

Whenever the stove is switched from one mode to another while in operation, the stove will enter the "start- up" sequence for a minimum of 20 minutes.

DISCONNECT POWER BEFORE SERVICE

H

 

E

REMOTE

A

HIGH

T

AUTO

 

O

MANUAL

MED

U

 

TAUGER

P LOW

U

 

FAULT

T

 

 

 

 

AUTO

H

UP

OFF

EMANUAL

A

T DOWN MANUAL

UP START

F

AMANUAL

N

DOWN

AUGER

TM

TRAVIS INDUSTRIES

HOUSE OF FIRE

NOTE: if using a modulating remote, this light will come on to indicate the remote is controlling the heater.

These indicator lights are used to determine which mode you are in.

Use the mode switch to determine the mode.

Travis Industries

Newport

2 9 0 9 0 2

Image 19
Contents Newport Page Introduction Important Information Introduction1Travis Industries Newport 0 9 0 2Safety Precautions Mobile Home Safety Precautions4Table of Contents Specifications 6Installation Clearances Straight Installation Installation7Clearances Corner Installation Venting the Pellet Stove 8InstallationMaximum Venting Distance Pellet Vent Termination See the illustration below Installation9Installing the Pellet Vent Pellet Vent TypeMobile Home Requirements 0InstallationOutside Air used for combustion Not Enough Air Installation1Alcove Installation Requirements Setting the RestrictorInstallation Example Direct Through-the-wall Installation 2InstallationInstallation Example Interior Vertical Installation Installation Example Class a Chimney Retrofit 4InstallationInstallation Example Hearth Fireplace Masonry or Z.C. metal Starting the Heater for the First Time Safety Notice6Operation Location of ControlsLoading Pellets Operation1Two Modes of Operation 8Operation Manual ModeTo Adjust Room Temperature or Start the Stove Auto ModeAdjusting the Fan Speed Restrictor Adjustment0Operation Operation2 Make Sure Pellets are Not Piling Up 2MaintenanceDaily Maintenance whenever using the stove Inspect the BurnCleaning the Firepot Maintenance2Check Firepot for Clinkers Cleaning the Optional Gold Surfaces Door and optional Grill 4MaintenanceBi-Weekly Maintenance or every 10 bags of pellets Clean the Heat Exchange TubesOpening The Door Let the stove cool completely before conducting serviceSweep Ash Into Ashpan 6MaintenanceCheck Ashpan, Dispose if necessary Clean the GlassYearly Maintenance or every two tons 8MaintenanceClean the Vent make sure the stove and vent is cool Replacement Parts 0MaintenanceCheck for Air Leaks Around the Door, Glass, and Ashpan Exhaust Blower Normal Operating SoundsSerial No Safety LabelYears 1 & 2 Coverage Parts & Labor Limited 7 Year WarrantyThermostat 4Optional EquipmentOptional Equipment Using the Remote ThermostatRemote Thermostat Optional Log 6Optional EquipmentOptional Gold Door Optional Gold Grill38Index