Casablanca Fan Company 55058, 55061 operation manual Switch Housing

Page 15

Switch Housing

www.CasablancaFanCo.com

1.888.227.2178

Screw two housing assembly screws

Feed the wire plug through the center

Insert the third screw, found in

from the

 

hardware bag halfway into

hole of the upper switch housing, then

the

 

 

hardware bag, into place and

 

 

 

 

the motor housing. It does not matter

wrap keyhole slots around the screws and

 

then tighten all three screws.

which two screw holes you choose.

twist counterclockwise.

 

 

 

 

15

Make sure the upper switch housing is securely attached to the mounting plate. Failure to properly secure all 3 assembly screws could result in the switch housing fixture falling.

M6021-01 • 04/16/15 • © 2013–2015 Casablanca Fan Company

Page 14 Page 16
Image 15
Page 14 Page 16
Contents
Table of Contents What to Expect with Your Installation Tools Needed Angled Standard Support Mounting StructureCeiling Outlet BoxFor angled ceilings, point Opening toward peak Ceiling BracketPreparation Downrod Steps 1-5 to remove standard downrod pipeSteps 6-10 to reassemble with new pipe Leave at least 8 extending Remove the pre-installed Hand tighten the downrod atTighten the setscrew Setscrew so that the downrodDo not Pick the FAN UP by Put the wires and downrod through the canopyAssembly as shown WiringOM F Using the orange wire connectors from the hardware bagWall Control BeforeAfter Holes CanopyBlades Switch Housing Socket Shade Socket Ring Socket Ring Tool Light KitTo the short chain coming from Hardware bag With bulbs of the same wattage Switch housingOperation Battery Holder DoorLights Down Battery HolderFan SpeedMaintenance & Cleaning Light PullChain Fan doesn’t work TroubleshootingUnpairing Procedure for Faulty Operation of Remote Controls