VERSA•TOUCH OPERATION
Fan Control
To start the fan. Press the selected speed button to run the fan at the desired speed.
LO=Low speed MED=Medium speed HI=High speed
To turn off the fan. Press the FAN OFF button.
Airflow Direction
To reverse the airflow press the REVERSE button. Reverse operates at any speed whether fan is on or off. The fan returns to its set speed after reversing.
Light Control
Turn the light on or off independently from the fan by pressing the UP LIGHT, DOWN LIGHT, OR BOTH button. (This is a rocker switch. Press the left side for the Up Light, right side for the Down Light, and the middle for both.) Keep pressing the button in excess of 0.7 seconds, it becomes a dimmer. The light varies from ‘bright’ to ‘dim’ over approximately 8 seconds. This sequence will reverse the light when it reaches the brightest or dimmest level if you continue to hold the LIGHT button. Release the button when the desired level is reached.
Auto Resume
Quick (pressing less than 0.7 seconds) on/off operation of the LIGHT button maintains the desired brightness level set previously.
SEND SIGNAL
LED
VERSA•TOUCH ♦ CHANGING FREQUENCY SETTING
Note: All fans leave the factory set to ‘00000’.
You will only have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately.
Step 1. At the circuit breaker or fuse box, turn the power off for the fan you want to change.
Step 2. Open the battery door of the Versa•Touch control and remove the batteries.
Step 3. Change the dip switch settings, assuring that they are different from the previously installed Versa•Touch fan.
Step 4.
Step 5. At the circuit breaker or fuse box, turn the power back on for the fan whose frequency you are changing.
Step 6. Within 20 seconds of restoring power, push the Hi, Med, and Lo buttons (in that order).
Note: You may want to label your controls to assure you do not mix them up.
WARNING: Do not turn the power off at the circuit breaker, then back on, for the previously installed Versa•Touch fan(s), as you may inadvertantly change the frequency settings for it as well.
VERSA•TOUCH
CONTROL
(BACK)
DIP SWITCH | DIP SWITCH |
SET TO ‘10000’ | SET TO ‘01001’ |
3 2 1
WITHIN 20 SECONDS OF TURNING THE FAN ON, PRESS IN THIS ORDER TO SET NEW FREQUENCY:
1.HI
2.MED
3.LO
VERSA•TOUCH ♦ IF FAN DOES NOT WORK
If the fan is not functioning after installation:
Step 1. Check to make sure that batteries are installed correctly in the control.
Step 2. Turn the power off to the fan (from the circuit breaker) for at least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and push the Hi, Med, and Low
CIRCUIT BREAKER
OR FUSE BOX
3 2 1
PRESS IN THIS ORDER TO SET NEW FREQUENCY:
1.HI
2.MED
3.LO
9