BELLA™
INSTALLATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
WORK BENCH SETUP
Setup. Remove the bottom foam from the box and place the fan rightside up in the foam. This protects the lamp socket during assembly.
NOTE: The fan weight is 30 pounds.
NOTE: If this is the second Versa•Touch fan installed in the same
area, one of the fans MUST have its channel changed. Please refer
to the Versa•Touch section on the bottom of page 9.FOAM
WORK BENCH
PERMA•LOCK™ HARDWARE
ALLEN SET SCREW
DOWNROD & BALL
ASSEMBLY
3mm
ALLEN WRENCH
FAN PREPARATION
IMPORTANT SAFETY INFORMATION! | GROUND |
WIRE | |
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, INSTALL THE |
|
THREADED DOWNROD INTO THE MOTOR COUPLING AND LOCK THE ASSEMBLY |
|
|
|
MOTOR
WIRES
DOWNROD
Prepare for fan installation as follows:
Step A. Place the downrod through the motor cover as shown. Route the wires from the fan motor through the Perma•Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread that is designed to lock completely when correctly installed.
Step B. Using the provided allen wrench, loosen the set screw several turns to allow installation of the downrod. Thread the downrod into the motor coupling until it stops turning, this will take at least four and a half full turns.
Step C. Securely tighten the set screw with the provided allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the down- rod before securely tightening the allen set screw may cause the fan to separate from the downrod during normal operation!
MOTOR
COVER
ALLEN
SET SCREW
&BALL
ASSEMBLY
TAPERED
THREAD
ATTACH MOTOR COVER
Step D. Using the three screws provided, attach the motor | MOTOR COVER | |
cover to the motor. Tighten firmly by hand only. | ||
SCREWS (3) | ||
|
3