INSTALL INCANDESCENT BULBS
Step E. Install the four 40 watt incandescent light bulbs. | INCANDESCENT |
| LIGHT BULBS |
| (4) |
CEILING HARDWARE
CROSSBAR | WIRE NUT (4) |
MOUNTING |
|
BRACKET |
|
ADDITIONAL HARDWARE
21/4″ x
SCREWS (2)
1″ x | FLAT WASHER (2) | |
HEAD SCREWS (2) | ||
|
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock, or personal injury, mount to outlet box marked ac- ceptable for ceiling fan support using the mounting hardware provided with the outlet box.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker or fuse box), lower the old fixture and disconnect the wiring. Check the ceiling fixture outlet box to be sure that it is marked ‘Approved for ceiling fan mounting’. If it is not, a new box must be installed.
NOTE: The fan weight is 30 pounds.
CROSSBAR MOUNTING BRACKET INSTALLATION
Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through the crossbar mounting bracket center hole. Attach the bracket, with ground wire and ridges down, to the ceiling fixture out- let box with the mounting hardware included with the outlet box.
Tighten the screws firmly by hand only, being careful not to bend the bracket by over tightening.
CAUTION: To reduce the risk of personal injury, use only the mounting hardware provided with the approved outlet box to install the crossbar mounting bracket.
CEILING
WIRING
CROSSBAR MOUNTING BRACKET
FLAT
WASHER
CEILING FAN
APPROVED
WIRING BOX
RIDGE
SIDE
DOWN
GREEN
GROUND
WIRE
APPROVED
OUTLET BOX
HARDWARE
CANOPY HARDWARE
CANOPY SCREW (4)
CANOPY HATCH
CANOPY | CANOPY LOCK WASHER (4) |
4