Installing the Interposer Extender
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized is not covered by warranty. Read and follow the safety instructions that came with the product.
1Hold the card by its edges, position the interposer extender so that the edge connector aligns with the system board connector. See Figure
2Insert the card edge connector firmly into the system board connector until the card is fully seated.
3Replace the two screws securing the interposer extender to the sled tray. See Figure
4Connect the power cable to the interposer extender. Press down on the locking tab to secure the power cable. See Figure
5Replace the
6Replace the internal
7Replace the back cover. See "Installing the Back Cover" on page 141.
8Replace the sled. See "Installing a Sled" on page 134.
Node Power Distribution Board
Removing the Node Power Distribution Board
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized is not covered by warranty. Read and follow the safety instructions that came with the product.
1Remove the sled from the enclosure. See "Removing a Sled" on page 133.
2Remove the back cover. See "Removing the Back Cover" on page 140.
3Remove the internal
184
Installing System Components
