
1 | release latch | 2 | handle |
Installing a Sled
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized is not covered by warranty. Read and follow the safety instructions that came with the product.
1Orient the sled so that the release latch is in the bottom of the sled. See Figure
2Slide the new sled into the enclosure until the sled is fully seated and the release latch snaps into place. See Figure
Sled Blank
CAUTION: To ensure proper airflow in the system, if a module is removed it should be immediately replaced with another sled or sled blank.
The information in this section include replacement procedures for the
Removing a Single-Wide Sled Blank
1Pull up on the sled blank latch at the bottom of the sled to disengage the sled from the server enclosure. See Figure
2Using the handle, slide the sled out of the enclosure. See Figure
134
Installing System Components