Dell C8220 owner manual Sled Covers, Installing a MicroSD Card, Removing the Front Cover, 138

Installing a MicroSD Card

Media memory cards are generally marked with a symbol (such as a triangle or an arrow) or a label to indicate which end to insert into the slot. The cards are keyed to prevent incorrect insertion. If card orientation is not clear, see the documentation that came with the card.

NOTE: To use a MicroSD card with your sled, ensure that the MicroSD card slot is enabled in the System Setup program. See "Using the System Setup Program" on page 45.

1Hold the MicroSD card with the label side facing to the right. See Figure 3-7.

2Press the card into the slot to lock into place. See Figure 3-7.

If you encounter too much resistance, do not force the card. Check the card orientation and try again.

3Slide the sled into the server enclosure until the sled is fully seated and the release latch snaps into place. See Figure 3-7.

Sled Covers

Removing the Front Cover

CAUTION: The sled must be operated with the sled covers installed to ensure proper cooling.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized is not covered by warranty. Read and follow the safety instructions that came with the product.

NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system.

1Remove the four screws securing the front cover. See Figure 3-8.

2Lift the front cover from the sled tray. See Figure 3-8.

3If installed, disconnect all cables from the expansion card.

138

Installing System Components