Dell C8220 owner manual 194

4Connect the following cables to the system board.

–I2C cable. See Figure 3-43.

–System board control cable. See Figure 3-42.

–SATA cable. See Figure 3-41.

–Power cable. See Figure 3-40.

5You must route the cables properly on the sled tray to prevent them from being pinched or crimped.

6Install the node power distribution board. See "Installing the Node Power Distribution Board" on page 186.

7Install the interposer extender to the new board. See "Installing the Interposer Extender" on page 184.

8Install the hard-drive tray. See "Installing the Hard-Drive Tray" on page 182.

9Install the hard-drives. See "Installing a Hard-Drive Carrier" on page 179.

10Install the MicroSD card reader support bracket. See "Installing the MicroSD Card Reader Support Bracket" on page 177.

11Install the MicroSD card reader. See "Installing the MicroSD Card Reader" on page 175.

12Transfer the processors to the new system board. See "Removing a Processor" on page 147 and "Installing a Processor" on page 148.

13Remove the memory modules and transfer them to the same locations on the new board. See "Removing Memory Modules" on page 153 and "Installing Memory Modules" on page 154.

14Replace the cooling shroud. See "Installing the Cooling Shroud" on page 142.

15If applicable, install the mezzanine card. See "Installing the Infiniband Mezzanine Card" on page 169 or "Installing the 10 GbE Mezzanine Card" on page 172.

194

Installing System Components