BELLA™
INSTALL BLADES
Step 10. Using the blade holder screws from the pack, attach each blade/blade holder as- sembly to the motor (two screws per blade). Use the blade access hole to install the screws.
Using the screwdriver, tighten securely by hand only.
BLADE HOLDER
SCREW
BLADE ACCESS PLATE INSTALLATION
Step 11. Using the two screws removed in Step 9, reinstall the blade access plate to the fan as shown.
Using the screwdriver tighten securely by hand only.
INSTALL HALOGEN BULB AND GLASS
Step 12. Screw the 100 Watt Halogen bulb into the socket. Do not touch the glass bulb with your
IMPORTANT! When installing the halogen bulb, care- fully cut off the end of the plastic sleeve the bulb comes in and hold the bulb by the plastic sleeve to
screw it into the socket. | TABS |
| |
| HALOGEN BULB |
| 100 WATT |
Step 13. Position the indentations in the outer rim of the glass shade so that they line up with the tabs on the inside surface of the fan light fixture rim.
Step 14. Carefully lift the glass shade up inside the light fixture as far as it will go.
Step 15. Rotate the shade in a clockwise direction until it is held tightly in place by the three tabs.
GLASS SHADE
GLASS SHADE INDENTATION
7