Bryant FF1DNA, FF1DNE manual Sizes 018, 024, Form No. PDS FF1D.18.2, Features

	FF1DNA,
FAN COIL UNITS	FF1DNE
	Sizes 018, 024, 030

	FEATURES
	The FF1DNA and FF1DNE Fan Coil units are designed as
	upflow indoor air handlers for split-system heat pumps and air
	conditioners. They are available with factory- or field-installed
	electric heaters both of which include the disconnect. A field-
	installed cooling control with disconnect is also available. A TDR
	(Time Delay Relay) is included with either the electric heat or
	the cooling control packages. The FF1DNE models are avail-
	able with a factory installed TXV.
	This fan coil may be installed free standing, wall hung or flush
	mounted in the wall. The 22-in. wide cabinet size in all models
	allows units to fit between standard stud spacings. No return air
	ductwork is required if the application provides for return air in
	the front of the cabinet through either a louvered closet door or
	an optional accessory decorative grille panel.
	The cabinet exterior is made of pre-painted galvanized sheet
	metal. The cabinet is fully insulated to meet applications in con-
	ditioned space. Additional insulation is required if the unit is
	installed in an unconditioned space. Unit is supplied with
	replaceable filter.
	Multispeed direct-drive PSC blower motors have been selected
	to provide the proper air handling for both heating and cooling.
	Motors are suspended at 3 points on rubber grommets for qui-
	eter operation.
	All refrigerant lines, electrical power, and thermostat wiring
	enter from the top of the cabinet. Sweat-type refrigerant con-
	nections on both liquid and suction lines make for swift, low-cost
	installation. All service access to the unit is conveniently located
	in the front.
	The CHECK-FLO-RATER®piston ensures efficient and
	dependable refrigerant metering, and eliminates potential ser-
	vice requirements of other metering devices. The CHECK-FLO-
FF1D	RATER® is located inside the unit, easily accessible for piston
	maintenance or changeout.
	In addition, units can be factory ordered with a hard shut-off
	thermostatic expansion valve (TXV) metering device for perfor-
	mance improvement.
	The drain pan is constructed of high-impact, sound-deadening,
	corrosion-proof polyester resin. Primary and secondary drain
	connections exit from the bottom or either side of the cabinet.

Form No. PDS FF1D.18.2