Maintenance
Cleaning the Dustcup
.
Screen
Dustcup
Cleaning the Filter
Latch
Hold dust cup handle in one | Empty the dust cup into | Hold dust cup handle in one | Pull dust cup latch to release |
hand and the bottom of dust | the trash container. Wipe | hand and the bottom of dust | dust cup. Remove filter |
cup in the other, turn dust cup | debris off screen. | cup in the other, line up arrow | and wash. Allow to air dry |
counter clockwise to unlock the |
| on dust cup with unlock icon | thoroughly (24 hours) before |
cup from the lid. |
| on backside of dust cup. Turn | placing back in dust cup |
|
| clockwise to lock the cup to |
|
|
| the lid. |
|
Replacing the Belt
Unplug vacuum. Recline cleaner | Using thumbs, push down on height | Lift left side of brushroll out of | ||
back. Using Philips screwdriver, | adjust knob, while pulling up on | grooves. Then lift right side of | ||
remove 4 screws from hood. | inside hood edges with fingers. Lift | brushroll out of grooves. | ||
| and remove hood. |
| ||
|
|
|
|
|
|
|
|
|
|
| Grip the brushroll and belt as shown. |
| |
Remove belt from the brushroll and | Line up corners of hood and put | ||
Stretch belt and push the right side of | |||
motor shaft. Loop new belt over | brushroll into grooves. Lower left side of | hood tab inside the front of cleaner. | |
motor shaft and brushroll, onto grey | brushroll into grooves making sure both | From front to back, push hood | |
belt pulley. | sides are secure by pushing down. Rotate | onto base, keeping hood in base | |
| the brushroll with hands to make sure belt is | grooves, and line up 4 screw holes. | |
| in center of gray pulley. | Replace 4 screws. |