C
B
Remove filter (B) from top of cup.
Empty cup, making sure to hold cup with dirt port (C) facing up.
Pivot cyclonic cone away from filter and push filter inside out through filter frame.
D
E
Brush the surface of filter to remove any clinging litter. (Filter and cone may be washed in warm water. They must be completely dry before replacing in clean- er. Do not use cleaner without filter and cone in place.)
Push filter back through frame and pull it right side out.
Pivot cone back into place.
Place filter assembly on top of cup as shown and push frame fully into cup.
Tab (D) on the frame fits down into slot (E) in the cup.
Slide filter assembly into cleaner body and latch cup into position.
F
G
H
Secondary filter
How to clean
Disconnect cleaner from electrical outlet.
The secondary filter (F)protects the motor from dirt particles and does not need to be removed for cleaning.
The filter is located on the inside top of the cleaner body and can seen when the dirt cup and filter are removed. When the filter becomes dirty, it can be cleaned by wiping it off with a damp cloth.
Brush roll
How to clean
Disconnect cleaner from electrical outlet.
To maintain cleaning effectiveness, peri- odically remove lint, strings, etc. from the brush roll either from the bottom of the nozzle (G) or by removing the Brush View Window, (H), on top of the nozzle.
To remove Window, turn cleaner over and remove 2 Phillips screws at each end of the nozzle. Turn cleaner over and lift off Window.
6