Hoover FloorMATETM The Hard Floor Cleaner owner manual

Page 4

1-3

B

1-4

1-5

With cord hook (B) to back of cleaner, push upper handle down onto cleaner. Insert screw with washer in front of tank area. Tighten screw with a Phillips screwdriver.

Insert two screws into back of handle as shown. Tighten with a Phillips screwdriver.

Replace clean solution tank by posi- tioning bottom first. Press latch and snap top portion into place.

1-6

D

1-7

1-8

E

C

F

To install brushes, place handle in upright position. Tilt cleaner back so that it rests on the floor.

Align post (C) on brush block with hole (D) on bottom of cleaner. Turn brushes slightly until post fits easily into hole.

Press brush assembly firmly to snap into place.

To install nozzle, make sure latches are out.

Align middle section (E) of nozzle with opening (F) on cleaner.

Remove cardboard packing insert from squeegee area on underside of nozzle.

1-9

While holding nozzle in place, slide latches inward to lock in place.

4

Image 4
Contents FloorMATE Hard Floor Cleaner Recommended cleaning Cleaning sealed wood floorsIndex 10-11Assembly Carton contentsQuestions or Concerns? Grounding InstructionsPage ON/OFF Switch Handle Release Pedal How to useTo transport General Operation TanksRecovery Tank lower tank Automatic Shut-Off WET modeTo Clean Filter How to EmptyTurn cleaner off and disconnect from electrical outlet To Clean Floor vinyl, tile, linoleum, etc How to cleanDry hands and plug cleaner into a properly grounded outlet Maintenance Cleaning Sealed Wood FloorsCleaning the brushes Dry hands and plug cleaner in to a properly grounded outletCleaning the Nozzle StorageIf you have a problem ServiceFull One Year Warranty Domestic UsePage Assembly Assemble handle