Power Switch Setting, Cleaner Lock Release

	PREPARING TO USEYOUR CLEANER	CARPET CARE CONTROL
		SELECTOR
	Insert handle into body of cleaner. Slide into position.	The carpet care control selector raises or lowers the
	Ensure handle is flush with body of cleaner.	height of the nozzle. The nozzle height will not change
	Tighten large screw (pre-fitted to handle upper hole).	until the handle is released. Try various settings until you
	Insert small screw into handle lower hole and tighten.	get the best results for each of your carpets.
		1
	Check that the dust container is fitted.	IMPORTANT: When cleaning hard
	Check that the dust container is fitted.	floors such as vinyl or linoleum, move
		floors such as vinyl or linoleum, move
		the “Carpet Care Control Selector” to
		the Hard floor position. Failure to do so
		! may cause damage to the floor surface.
		Ensure that the cleaner
		is in an upright (parked)
		position.
		Slide selector to the
		position best suited to
		depth of carpet pile.

POWER SWITCH SETTING

Switching on and off

Using this cleaner for carpets with pile greater than 30mm is not recommended.

Unlock the cleaner by pressing down on pedal with foot. For floor cleaning under low furniture and some

maintenance tasks

simply press the

pedal again and lower handle to the floor.

Push bottom of the On/Off switch to switch on. Push top of the On/Off switch to switch off.

- -

0565-5289.indd 4

28/11/2007 15:43:22