Bissell 7700 warranty Getting ready to wet clean, Place the clean solution tank on a flat surface

Page 10

Operation

Getting ready to wet clean

NOTE: Remove tool caddy if in place.

1.Attach the desired wet cleaning tool to end of wand or grip.

2.Open the Quick Release™ Hose Door and select “WET CLEAN” with the mode selector.

3.Place the clean solution tank on a flat surface.

4.Fill the solution tank by first unscrewing the measuring cap. Always use genuine BISSELL formulas to maximize cleaning and for the safety of your machine. Fill tank to fill line with hot tap water. Add two full measuring caps of formula. Screw measuring cap tightly back onto the solution tank.

5.Place the solution tank back in the machine.

6.Make sure the float is in place. To install, slide float into the channel located on "Fill Line" side of the collection tank. There is only one way to properly install the float.

7.Plug into a proper outlet and press the ON/ OFF, wet clean and heater (if desired) buttons down into the ON position.

Note: Allow one minute for the built-in heater to warm up before cleaning. The Big Green Complete will be fully warmed and will provide optimal performance after one minute in the heater ON position.

1610 w w w . b i s s e l l . c o m

Tip:

Move furniture to another area if cleaning an entire room.

24a

4b4c

4d5

8 0 0 . 2 3 7 . 7 6 9 1

ug120-4004_7700_807.indd 10

10/30/07 3:39:45 PM

Image 10

Contents Big Green Complete Thanks for buying a Bissell Big Green Complete W w . b i s s e l l . c o m 0 3 7 6 9163 Product view water ﬁltrated vacuum mode Optional Accessories165 Product view wet cleaning modeSolution Tank Deep Cleaning Floor Nozzle Bissell FormulasHow to use this guide AssemblySpecial features of your Bissell Big Green Complete Wand caddy OperationQuick Release Hose Door Vacuuming169 Wet cleaningBefore you clean Emptying the tankPlace the clean solution tank on a flat surface Getting ready to wet cleanAttach the desired wet cleaning tool to end of wand or grip Place the solution tank back in the machine116 Carpet CleaningDo not overwet Set the solution tank back in the machine When you are finishedHard floor cleaning Allow all parts to dry before storingManufacturer’s tag 136Check for colorfastness in an inconspicuous place Cleaning fluid section Maintenance and careMachine storage Machine care 156Press all buttons OFF. Unplug the machine and wrap the cord Machine is not suctioning TroubleshootingReduce Spray or No Spray Built-in heater light does not illuminateM. 10 p.m. EST Bissell Consumer ServicesPO Box Grand Rapids MI Attn Consumer Services M. 8 p.m. ESTItem Part No Replacement parts Bissell Big Green CompleteNot all parts are included with every model Pads not included Limited One Year Warranty Warranty Bissell Big Green CompleteIf your Bissell product should require service